1 2 3 4
5 6 7
RC4WD Dress up Kit for 4Runner
and XTRAcab Engine Bay
1 2 3 4
5 6 7
(Foam safe CA, Shoe Goo,
E6000, Styrene Glue, Epoxy) Curved Lexan ScissorsHex Drivers (1.5mm, 2mm)
RC4WD non-electrical products are warranted to be free of defects in materials and workmanship when
new. Our limited warranty does not cover damages due to normal wear and tear, user error of assembly or
installation, user modifications, user's failure to perform routine maintenance, addition of aftermarket parts or
option parts. This warranty lasts 30 days after arrival for original purchaser.
In the event of a defect under this warranty, RC4WD will, at our discretion, replace the product, provided our
inspection indicates that an original defect exists. RC4WD reserves the right to replace any product which is
no longer available with a product of comparable value and function. If RC4WD determines the repair is not
covered under warranty guidelines, we will contact you to discuss your options. If you have any questions,
please contact us via email at [email protected].
RC4WD warranties its electronics for 30 days from date of arrival. This covers all electrical items except items
that are already noted on the individual product page.
CA Glue Glue
Attention Paint
Drill Hole Body ReamerTrim with Hobby Knife
Cut with Scissors
1. Carefully remove all pieces from parts trees with a hobby knife or side cutters. Take care to trim the
injection point from the parts.
2. Test fit everything before gluing. Many areas will require extra attention to detail to ensure proper alignment.
3. Paint 3d printed parts and allow 1 day of drying time before installing.
Recommendations for building your Dress up Kit for Engine Bay.
1 2 3 4
5 6 7
Z-B0247
325-1375 325-1376 325-1377 325-1378
x2
ø3.0mm
ø2.5mm
ø1.3mm
Drill Tool
Heat Shrink Tubing
13mm / Ø2.5mm
Electric Wire (Yellow)
For battery cable and battery ground For radiator hose
For spark plug cable, distributor and coil
55mm / Ø1.3mm
Electric Wire (Black)
40mm / Ø1.3mm
Black Hose
80mm / ø1.5mm Ø2.5mm x2 x2
Black Hose
75mm / ø1.5mm Ø2.5mm
Black Hose
70mm / ø1.5mm Ø2.5mm
Black Hose
32mm / ø4mm Ø5mm
Electric Wire (Red)
75mm / Ø1.3mm
Electric Wire (Yellow)
75mm / Ø1.3mm
150-0327
M1.6 x 4mm SHSTS
x4
Electric Wire (Red)
110mm / Ø1.3mm
Electric Wire (White)
75mm / Ø1.3mm
Electric Wire (Red)
135mm / Ø1.3mm
For battery cable
LEGEND
øINNER
DIAMETER
OUTER
DIAMETER
Ø
RC4WD Dress up Kit for 4Runner
and XTRAcab Engine Bay
1 2 3 4
5 6 7
8
Step 1. Drill hole 1~7. (ø: 1.3mm).
Step 3. Drill hole 9. (ø: 1.3mm).
9
1
2 3
7
4
5
6
Step 2. Drill hole 8. (ø: 1.3mm).
Use 325-1376 and place in general area
shown in image, use pencil to mark holes.
RC4WD Dress up Kit for 4Runner
and XTRAcab Engine Bay
1 2 3 4
5 6 7
Step 6. Drill hole 15 & 16. (ø: 3mm).
15
16
Step 4. Drill hole 10~13. (ø: 2.5mm).
10 11 12 13
Step 5. Drill hole 14. (ø: 3mm).
14
RC4WD Dress up Kit for 4Runner
and XTRAcab Engine Bay
1 2 3 4
5 6 7
Step 8. For the installation of the soft hose and wire decoration, please refer to the diagram below.
For wires and tubes insert them into corresponding drilled holes and attach them with glue.
Wrap the wires together first, then add a few
dots of super glue to hold the wires together.
Add heat shrink tubing here.
Insert wires into hole 15.
Insert battery ground wire into hole 8.
Radiator hose tucks in under the air box tube.
15
8
110mm
40mm
32mm
75mm 55mm(Yellow)
135mm(Red)
Step 7. Install accessories.(Z-S2052)
Socket Head Self Tapping
Screws M1.6 X 4mm
Socket Head Self Tapping
Screws M1.6 X 4mm
Socket Head Self Tapping
Screws M1.6 X 4mm
RC4WD Dress up Kit for 4Runner
and XTRAcab Engine Bay
1 2 3 4
5 6 7
80mm
110mm
55mm(Yellow)
135mm(Red)
75mm
Step 8. Continued
80mm
70mm
75mm
75mm
RC4WD Dress up Kit for 4Runner
and XTRAcab Engine Bay
Step 10. Install in the 4runner.
1 2 3 4
5 6 7
Step 9. Install in the 4runner.
(Note: can also be installed directly on the TF2 Chassis Motor Mount, see Step 20.)
150-0196
M3 X 10mm
BHSTS
8
RC4WD Dress up Kit for 4Runner
and XTRAcab Engine Bay
Step 12. Install in the TF2 chassis
Step 11. Can also be installed directly on the TF2 Chassis Motor Mount.
150-0100
M3 X 8mm
FHCS
1 2 3 4
5 6 7
1 2 3 4
5 6 7
100-0121
720 N. Gateway St.
Visalia, CA 93291
Web: www.rc4wd.com - Email: [email protected]
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
RC4WD Fender Flares User manual
-
-
-
-
-
-
-
-
-
