Installation Instructions for Interior Wood Doors
1. Prepare the rough opening.
a. Are the walls straight?
b. Are the uprights level?
c. Is the subfloor clean, dry, level and solid?
2. Put fasteners in jambs just above the hinge positions on the hinge jamb.
Leave fasteners sticking out a little.
3. On hinge jamb only, place one shim behind each hinge between the hinge
jamb and the wall stud. Check hinge jamb for plumb and true with a 6-foot
level. Drive a fastener through each shim and remove excess shim.
4. Shim between the strike side jamb and wall stud near the top and bottom of
the jam, across from the top and bottom hinge locations. Adjust the frame so
it is flush with the face of the door. Drive fasteners through jambs at locations
of top and bottom shims and remove excess shims.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Masonite 10201 Installation guide
-
Stanley Doors FWM1536P-P32LZ Installation guide
-
Stanley Doors 1907M-32-R Operating instructions
-
Stanley Doors 600015 Operating instructions
-
Ashworth 5014038 Installation guide
-
Steves & Sons ST90-PR-S12MB-R6RH Installation guide
-
Steves & Sons SIP0000012211 Operating instructions
-
Pacific Entries F23ML6 Operating instructions
-
Feather River Doors MQ2E94 Installation guide
-
