Extron CS 123T Template

Type
Template

This manual is also suitable for

68-2328-01 Rev. C
11 14
Important Note: Print 1:1 only.
Do not scale.
9.075” (230.505 mm) cutout diameter
1. Mark the location where the speaker
will be centered and installed.
2. Align the center hole of the template
with the mark.
3. For speaker installation into fiberglass
ceiling tile only, go to the Fiberglass
Tile Adapter Instructions box on the
right. Otherwise, proceed to step 4.
4. Trace a circle around the cutout template.
5. Cut out the traced circle.
Cutout Template Instructions
a. Place the Fiberglass Tile Adapter around
the outer diameter of the template.
b. Trace a circle around the outer diameter
of the berglass tile adapter.
c. Proceed to step 5.
Fiberglass Tile Adapter Instructions
SpeedMount
®
Ceiling Speaker System
Cutout Template
  • Page 1 1

Extron CS 123T Template

Type
Template
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI