Extron CS 1226T Template

Type
Template
68-2328-01 Rev. B
03 13
Important Note: Print 1:1 only.
Do not scale.
9.075” (230.505 mm) cutout diameter
CS 26T / CS 120P
Cutout Template
1. Mark the location where the speaker
will be centered and installed.
2. Align the center hole of the template
with the mark.
3. For speaker installation into fiberglass
ceiling tile only, go to the Fiberglass
Tile Adapter Instructions box on the
right; otherwise proceed to step 4.
4. Trace a circle around the cutout template.
5. Cut out the traced circle.
Cutout Template Instructions
a. Place the Fiberglass Tile Adapter around
the outer diameter of the template.
b. Trace a circle around the outer diameter
of the fiberglass tile adapter.
c. Proceed to step 5.
Fiberglass Tile Adapter Instructions
  • Page 1 1

Extron CS 1226T Template

Type
Template

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI