ESMR

Danfoss ESMR Installation guide

  • I have reviewed the provided installation guide for the ESMR device. This document covers important aspects of installation, including cable connections, mounting and cover removal. I'm ready to assist you with any questions you may have regarding the described device and procedures.
  • Is the polarity important when connecting the wires?
    Are screws included for wall mounting?
    How to remove the cover?
ENGLISH
ESMR
1. Feed cable through the inlet in center
of the backplate or through the left
side inlet. Press the orange tabs to
connect wires. Polarity not important.
2. Mount on wall with screws (not
included).
3. Snap on cover over hooks at top and
bottom.
Removal of cover
4. Press tabs to remove cover.
DANSK
ESMR
1. Før kablet gennem åbningen i
bagpladens centrum eller gennem
åbningen i venstre side. Tryk på
de orange paler for tilslutning af
ledninger. Polaritet er ikke vigtig.
2. Montér på væg ved hjælp af skruer
(ikke medleveret).
3. Klik frontdækslet på bagpladen i
henholdsvis top og bund.
Aftagning af frontdæksel
4. Tryk på tappene for at aftage
frontdækslet.
© Danfoss | 2021.09 AN39112973488901-000101 | 1
ESMR
Installation Guide
2 | © Danfoss | DCS-SGDPT/DK | 2021.09 AN39112973488901-000101
*087H9341*
? ESMR: www.danfoss.com
? https://www.youtube.com/user/DanfossHeating
-> Playlists -> How-to Videos -> District Energy installation videos
ENGLISH
Dimensions
A” = Cable inlet from left
“B” = Cable inlet from back
“C” = Terminal block for cable connection
“D” = Cover
DANSK
Dimensioner
A” = Kabel-indgang fra venstre
“B” = Kabel-indgang fra bagside
“C” = Klemrække for ledningsforbindelser
“D” = Frontdæksel
Installation Guide, ESMR
1/2