ELECTRICAL INSECT KILLER
IK-5940
Insects such as mosquitoes, flies and various other bugs, etc are attracted by UV Light. This unit operates with a modern
maximum efficiency, the UV lamp attracts and the powerful suction system pulls the flying insects to the electric grid which
could kill them by high voltage electric shock.
1. Convenient with remote function.
2. Non-Corrosive Aluminum alloy shell construction.
3. The unit can be suspended from ceiling, shelf mounted or free standing.
4. Low Consumption, safe, and effective.
5. Easy to operate and clean.
6. Environmentally friendly with no chemicals.
Ideal for Home and Commercial use.
1. Before use, ensure that the power plug is connected to a properly installed wall socket that is easily accessible and the
supply voltage matches the rating plate.
2. Ensure the power socket used is properly earthed.
3. In order to get the best results, ensure that this product is placed appropriately so that it will have maximum impact
against the insects.
4. To operate the appliance, turn the switch on the product to“I”position or press the“ON”button on the remote control.
Switch to“O”position or press the“OFF”button, you could turn off the product. Only the main switch is on“I”position, the
remote control works.
5. Once the power supply is switched "On" you should see the tube emitting purple light. This indicates that the product is in
operation.
6. It is normal to hear a cracking or zapping sound when insects touch the electrified net.
7. After a period of use, the bottom tray may need cleaning. Firstly, please cut off the power and remove the plug from the
socket. Ensure that the outer grid is fully discharged to remove any residual charge. This can be done using a screwdriver to
short any two grid wires. Please be cautious while doing this and ensure that the screwdriver is held using the insulated
handle. Repeat the procedure with the inner grid. Then remove the bottom tray to clean.
1. Ensure that the voltage and the frequency indicated on the rating label matches the mains voltage before plugging in the
appliance.
2. Do not operate the appliance if it or the power cord show visible signs of damage.
3. Ensure that the power cord cannot be damaged by sharp edges or hot surfaces. If the power supply cord is damaged, it
must be replaced by a qualified electrician.
4. To make sure the remote control works well, please use it according to the below specification:
① Working Distance: 8m-10m ② Receiver’s working angle: ±30°
5. Before replacing the lamp or cleaning the product, ensure that the power supply is switched off and the plug is removed
from the socket. Also, please make sure that the electric grid is fully discharged before touching any parts of the unit.
6. The appliance should be kept out of the reach of children or pets. Children should be supervised at all times to ensure
they do not play with or in any other way try to operate or come into contact with this appliance.