Page is loading ...
ACCESSORY INSTALL
INSTRUCTIONS
TION
Page
1
of
3
COOLER C
LEAT
Installation Instructions for the 130 Super Sport
Issue Date
10/23/2018
Rev.
A
PROCEDURE NO.
1.
PURPOSE
Provide step-by-step procedure for the cooler
cleat installation.
2.
SCOPE
This procedure is limited to the cooler cleat installation on the 130 Super Sport.
3.
DEFINITION
3.1.
Not Applicable
4.
RESPONSIBILITY
4.1.
Not Applicable
5.
TOOLS/EQUIPMENT REQUIRED
5.1.
Drill
-
Phillips head bit#2
-
1/8” drill bit
5.2.
Pencil
5.3.
Hardware Kit (supplied)
CONTENTS OF KIT PART #
COOLER CLEAT..........................2316014 (13SPT)
6.
SAFETY
6.1.
Safety glasses or goggles are recommended.
7.
FORMS
7.1.
Not applicable
ACCESSORY INSTALL
INSTRUCTIONS
TION
Page
2
of
3
COOLER C
LEAT
Installation Instructions for the 130 Super Sport
Issue Date
10/23/2018
Rev.
A
PROCEDURE NO.
8.
PROCEDURE
8.1.
Install port coaming cleat.
8.1.2.
Starting from the bench seat support detail,
measure 21.5” FWD. make a vertical mark
with pencil.
8.1.3.
Measure up from floor 10.75” at vertical pencil
mark. Make a horizontal pencil mark. Place the
coaming cleat AFT upper corner at pencil mark
intersection. Making sure cleat is level, mark
cleat fastener holes. Drill holes and secure
cleat with screws.
ACCESSORY INSTALL
INSTRUCTIONS
TION
Page
3
of
3
COOLER C
LEAT
Installation Instructions for the 130 Super Sport
Issue Date
10/23/2018
Rev.
A
PROCEDURE NO.
8.1.2.
Install INBD floor cleat.
8.1.3.
Measure 3” FWD from console floor detail,
Make a mark with a pencil.
8.1.4.
Measure ½” INBD from console make a mark
with a pencil.
8.1.5.
Align cleat with pencil marks on AFT end and
non-skid on FWD end, drill holes and secure
with screws.
Cooler Cleat Installation Is Complete
/
