Personal Audio System
Quick Guide
For Use With Roady2
™
Satellite Radio Receiver
white logo
white logo
white logo
Delphi Corporation
1441 West Long Lake Road • Troy, Michigan 48098-5090 U.S.A.
Customer Service: [1] 877.GO DELPHI
www.delphi.com
www.shopdelphi.com
The Roady2 name, XM name, and related logos are trademarks
of XM Satellite Radio Inc.
© 2004 Delphi Corporation. All rights reserved.
DPSS-04-E-069
Tuning XM Channels
Switch to XM mode, then use
your Roady2 controls as usual.
Tuning FM channels
Switch to FM mode, then move
the joystick to change channels.
A short tap and release will
tune to the next station. Hold in
either side for one second and
release it to seek until an FM
station is found. Tap the joystick
anywhere to stop.
Volume
It’s best to change the volume
using the joystick controls, but
you can also use the volume
control on your headset, or on
the Roady2 unit itself.
Using Your Roady2 Personal Audio System
FM button
Channel control
Volume control
Step 1:
Push down the latches on
both sides.
Step 2:
Slide the tray out.
Setting up Your Roady2
™
Personal Audio System
Note: Before using your Roady2 Personal
Audio System for the first time, it is
recommended that you fully charge
the battery. See your
Roady2 Personal
Audio System
User Guide
for more
information.
Caution: Turn down the volume before
using headset to avoid ear damage.
Important Things
to Know
Display
The Roady2 Personal Audio
System display shows the
mode (FM or XM), FM
station, battery charge indicator,
and volume. (XM channels
appear on your Roady2 display.)
Backlight
Any time you adjust the controls
or change modes, the blue
LED backlight comes on so
you can easily read the display.
Roady2 setup
See page 5 of your Roady2
User Guide for important setup
information.
Headset
Your Roady2 Personal Audio
System headset not only
produces great sound, it
contains a built-in antenna.
Keep the antenna in line of
sight with the satellite for best
reception. You can adjust the
volume with the control on
the right side.
Battery pack
To recharge the battery, plug
the AC adaptor into the unit
with the battery in place. The
Lithium Ion battery will fully
charge in about two hours
when the unit is turned off, but
you can charge it while using it.
The indicators at the upper left
part of the display indicate the
state of the battery.
Mode switch
Step 3:
Gently place your Roady2 into
the docking station and slide the
tray back in until latches click.
Step 4:
Plug in your headset.
Step 5:
Slide the mode switch to XM or FM.
Important: For Roady2 operating instructions,
consult the Roady2
User Manual that came
with your Roady2.
Step 6:
Remove your Roady2 by pushing down
the latches on both sides and sliding
the tray outward.
/
