2. BLOTZ
  3. B20-ME-104

BLOTZ B20-ME-104, B20_ME_104, BH0-ME-104 Assembly Instructions

  • I've reviewed the document for the BLOTZ Desert Fort B20-ME-104 Corner Tower. It outlines the steps for assembling the model, including how to attach the angled supports and which wall to leave off initially. I understand that tools like glue and a modeling knife are required. I'm here to answer your questions about the assembly process.
  • What materials are needed for assembly?
    What should I do with angled supports?
    Which wall should be left off initially?
20mm Desert Fort – Corner Tower
B20-ME-104
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue them together as shown above – Note the
angled supports have an arrow on them which
should point upwards.
Take the walkway and end wall sections.
Attach the walkway in place then add the LEFT wall
piece only. The RIGHT wall (with the arrow pointing
at it) should not be added at this point.
Take the tower roof and the two thinner tower
wall pieces.
Add them to the model as shown.
Add the other two tower wall pieces, then glue
the wall section that was left off earlier into place.
The finished model.
/