2. Fishbone Offroad
  3. FB21014

Fishbone Offroad FB21014 Installation guide

  • Hello, I am a chat assistant that has reviewed the provided installation instructions for the Fishbone Offroad Light Bar Bracket JK Wrangler 52". The document outlines the steps for installing the bracket on a Jeep JK Wrangler, noting the required 52" light bar size and the use of factory hardware. I am ready to answer any questions you may have about installing this product.
  • What size light bar does this bracket fit?
    Is the light bar included with the bracket?
    What tool is required for installation?
FB21014
Jeep® JK Wrangler
52” Light Bar Bracket
2101400
REQUIRED TOOLS
T-40 wrench
KIT CONTAINS
Gaskets (pre-attached to bracket)
Driver Bracket
Passenger Bracket
QTY
2
1
1
Ensure light bar is 52” mount to mount
Fishbone Offroad’s light bar bracket is designed to fit light bars that are 52” between the mounting
locations on the light bar. This means a 50” light bar will not fit without spacers (not included).
1) REMOVE FACTORY HARDWARE
Remove the upper five (5) factory bolts on your
windshield mount bracket using a T-40 wrench.
2) INSTALL LIGHT BRACKET
Ensure the light bracket has the foam backing pre-
installed. Place the bracket against the vehicle and
LOOSELY secure using your factory hardware. This
will make it easier to install your light bar.
3) REPEAT STEPS 1 AND 2 FOR OPPOSITE SIDE
4) INSTALL LIGHT BAR
Follow your light bar’s instructions on how to mount
the light. Once the light bar is securely mounted to
the brackets, tighten your factory hardware on both
sides.
* LIGHT BAR AND CUBE LIGHTS NOT INCLUDED
/