2. Fishbone Offroad
  3. FB21057

Fishbone Offroad FB21057 Installation guide

  • Hello! I've reviewed the installation instructions for the Fishbone Offroad Light Bar Bracket for Jeep TJ Wranglers. This document outlines the process for installing the light bar brackets, mounting a 52" light bar, and attaching optional cube lights. I'm ready to answer any questions you might have about using this product.
  • What tools are required for installation?
    What size light bar does this bracket fit?
    Are cube lights included in the kit?
FB21057
Jeep® TJ Wrangler
Light Bar Bracket
2105700
REQUIRED TOOLS
T-40 Torx
3/16 Allen Wrench
KIT CONTAINS
Light bar brackets (left and right)
5/16” Flat head socket cap screw
QTY
1 ea
8
Ensure light bar is roughly 52” mount to mount
Fishbone Offroad’s light bar bracket is designed to fit light bars that are 52” in overall length. Be sure
to check the manufacturer’s spec on overall length. Smaller light bars may require spacers (not
included).
1) REMOVE TOP FOUR (4) BOLTS
Remove the upper four (4) bolts from the windshield
hinges. OEM hardware requires a T-40 torx.
2) INSTALL LIGHT BAR BRACKETS
Place the corresponding light bar bracket on the Jeep
and loosely install with the supplied hardware.
NOTE: Keeping everything loose at this time will help
when installing the light bar.
* LIGHT BAR AND CUBE LIGHTS NOT INCLUDED
FB21057
Jeep® TJ Wrangler
Light Bar Bracket
2 2105700
3) INSTALL LIGHT BAR
Following your light bar manufacture’s instructions,
install the light bar.
4) TIGHTEN ALL BOLTS
Securely fasten all hardware after the light bar has
been installed and secured.
5) OPTIONAL – INSTALL CUBE LIGHTS
If desired, install cube or other small lights on the
tabs provided on the brackets.
6) WIRING
Wire your lights following your light manufacturer’s
installation instructions.
7) YOU’RE READY TO LIGHT UP THE TRAILS!
/