Cleveland MKDL-100-CC-T Datasheet

Category
Electric kettles
Type
Datasheet
SECT. XIV PAGE 1
0609
COOK/CHILL SWEEP/FOLD
VERTICAL AGITATOR
TILTING MIXER KETTLES
MODELS: MKDL-40-CC-T MKDL-100-CC-T
MKDL-60-CC-T MKDL-125-CC-T
MKDL-80-CC-T MKDL-150-CC-T
Cleveland Standard Features
I
Hydraulic powered Sweep/Fold Mixer Arms and Bridge Lift
I
Easily removable Blades scrape the entire jacketed surface area
I Agitator and Scraper are individually Bayonet mounted for
quick, easy removal
I Variable Scraper Speed Control
I Variable Ratio between Scraper and Agitator
I Safety Device to prevent high speed starts and mixing when
Bridge is even slightly lifted
I Solid state Temperature Controller with Digital Readout
I Time / Temperature Chart Recorder to provide permanent
record of Batch Processing
I Manual Tilt mechanism with roller bearings and self-locking
Worm and Segment gear
I All plumbing, electrical, and hydraulics are enclosed in
Stainless Steel Consoles
I Totally enclosed Stainless Steel Mixer Bridge
I Factory pre-wired Stainless Steel Control Center on
right hand Console (left console mounting optional)
I 316 Stainless Steel Kettle Liner for high acid products
I Large Pouring Lip with removable Flow Diverter
I Gallon Markings on Scraper Shaft
I Automatic Water Meter
I Hot and Cold Water Faucet with 3/4" Swing Spout
I Standard 50 psi Steam Jacket Rating on 40, 60 and 80 gallon
models; 35 psi on larger models
I Automatic Water Cooling System
I Air operated 3" Flush Piston Valve with console mounted
variable Control (requires air compressor)
I Console mounted Air supply with Quick disconnect for Food
Pump operation
I Two piece Lift-off Cover
I 10" long Product Valve Extension (for 100 gallon models and
larger)
I Accepted for use in U.S.D.A. Inspected Facilities
Options & Accessories
Ë 100 psi Steam Jacket pressure Option
Ë Control Center on left-hand Console
Ë Removable Pan Carrier
Ë
Kettle Accessory Kit (Paddle, Ladle, Whip and Brush Set)
Ë Cooking Baskets and Tri-Basket Support
Ë Pasta Basket and Dolly
Shall be CLEVELAND Model MKDL-___-CC-T, COOK/CHILL
TILTING MIXER KETTLE, ____ Gallons; Sweep/Fold Agitator, 2/3
Jacketed, Direct Steam, ___ psi Steam Jacketed Pressure Rating;
Hydraulic powered Agitator, Scraper, and Bridge Lift, Variable
Scraper Speed; All plumbing, electrical, and hydraulics are
enclosed in Stainless Steel Consoles; Removable Flow Diverter;
Time/Temperature Chart Recorder; Hot and Cold Water Faucet;
Automatic Water Meter; Automatic and Manual Water Cooling. 316
Stainless Steel Kettle Liner; Air Operated 3" Flush Piston valve with
variable Control; two piece Cover.
Ë Electric Chain Hoist for Product Loading
Ë Power Tilt Feature for kettle
Ë Half Moon Food Strainer
Ë 3", 90° Elbow
Short Form Specifications
Cleveland
P
roject ________________________________
Item __________________________________
Quantity _______________________________
F
CSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
COOK CHILL SYSTEMS
Cook/Chill Systems
SECT. XIV PAGE 1
1201
Litho in USA
Cleveland Range reserves right of design improvement or modification, as warranted.
N
(Trunnion
Centerline)
s
(Console O.D.)
T
(
Console O.D.)
C
(I.D.)
U
(Typ.)
G2
(Typ.)
C
E
2
D
2
K2
HH
J
J
Z
Z
B
KK
8.44”
20.00”
See
Detail C
Detail C
W
all
Tie bar for 80 gal. and up
F
loor slope:
1.00” per 4.00’
4.00” minimum
6.00 recommended
Recommended pipe
drain 4.00”
1
8”clearance
r
ecommended
for service
2 legs on 40-80 gal.,
3 legs on 100 gal. and up
10.38”
1
6.00”
6.5”
3.00”
6
9.75”
Lid
Console
0.13”(3)
Typ.
25.75”
1.75”
W
V
T
P
F2
N
N
5
.75”
6.50”
2.50”
2
.50”
L
L
7.25”
3
.00”
MINIMUM CLEARANCE
FRONT 36"
SIDE 12"
REAR 12"
SECT. XIV PAGE 2
0609
Litho in USA
Cleveland Range reserves right of design improvement or modification, as warranted.
DIMENSIONS (inches)
MODEL BCD2 E2 F2 G2 MNPSTUVWZHH JJ KK LL NN
MKDL-40-CC-T 58.00 26.00 40.75 50.25 69.50 7.75 36.38 23.13 36.00 10.00 18.00 26.50 7.75 5.25 6.50 39.00 13.50 5.48 5.38 74.50
MKDL-60-CC-T 61.50 29.50 44.25 53.75 74.00 11.25 39.13 23.13 36.00 10.00 18.00 26.50 7.75 5.25 6.50 40.75 13.50 5.48 5.38 79.00
MKDL-80-CC-T 65.00 33.00 46.25 55.75 78.50 13.25 39.88 23.13 36.00 10.00 18.00 26.50 7.75 5.25 6.50 40.75 13.63 5.69 5.38 83.50
MKDL-100-CC-T 69.50 35.50 48.25 57.75 82.00 15.25 41.13 23.13 36.00 12.00 18.00 26.50 7.75 5.25 6.50 40.75 14.56 6.56 5.38 87.00
MKDL-125-CC-T 74.00 40.00 48.75 58.25 87.25 15.75 40.38 23.13 36.00 12.00 18.00 26.50 7.75 5.25 6.50 46.00 14.56 6.48 5.38 92.50
MKDL-150-CC-T 74.00 40.00 53.48 62.94 91.94 20.48 44.00 23.13 36.00 12.00 18.00 26.50 7.75 5.25 6.50 46.00 14.56 6.48 5.38 96.94
UTILITY CONNECTIONS
CHILLED CHILLED
WATER WATER COLD HOT CONDENSATE AIR ELEC-
MODEL INLET RETURN WATER WATER STEAM RETURN DRAIN INLET TRICAL
MKDL-40-CC-T 3/4" 3/4" 3/4" 3/4" 3/4", 50 PSI 3/4" 3/8" 1/2" 9.2 AMPS
15 GPM 20 GPM 20 GPM 150 lbs/hr 1 CFM
MKDL-60-CC-T 3/4" 3/4" 3/4" 3/4" 3/4", 50 PSI 3/4" 3/8" 1/2" 12 AMPS
15 GPM 20 GPM 20 GPM 230 lbs/hr 1 CFM
MKDL-80-CC-T 3/4" 3/4" 3/4" 3/4" 3/4", 50 PSI 3/4" 3/8" 1/2" 12 AMPS
15 GPM 20 GPM 20 GPM 300 lbs/hr 1 CFM
MKDL-100-CC-T 3/4" 3/4" 3/4" 3/4" 1 1/4", 35 PSI 3/4" 3/8" 1/2" 15.3 AMPS
20 GPM 20 GPM 20 GPM 390 lbs/hr 1 CFM
MKDL-125-CC-T 3/4" 3/4" 3/4" 3/4" 1 1/4", 35 PSI 3/4" 3/8" 1/2" 15.3 AMPS
20 GPM 20 GPM 20 GPM 470 lbs/hr 1 CFM
MKDL-150-CC-T 3/4" 3/4" 3/4" 3/4" 1 1/4", 35 PSI 3/4" 3/8" 1/2" 15.3 AMPS
20 GPM 20 GPM 20 GPM 570 lbs/hr 1 CFM
208V/
3PH/60Hz
(NOT TO SCALE)
NOTES: The pressure drop is 12 to 15 PSI for steam and chilled water passing through the kettle.
Air must be dry, clean and free of oil.
  • Page 1 1
  • Page 2 2

Cleveland MKDL-100-CC-T Datasheet

Category
Electric kettles
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI