Cleveland Range IA-SE-CC Datasheet

Category
Wall & ceiling mounts accessories
Type
Datasheet

This manual is also suitable for

Cleveland
P
roject ________________________________
Item __________________________________
Quantity _______________________________
F
CSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
COOK CHILL SYSTEMS
Cook/Chill Systems
SECT. XIV PAGE 15
0609
COOK/CHILL CONTROL CENTERS
Single Remote Mounted Controls for
Horizontal or Inclined Mixer Kettles
MODELS:
HA-SE-CC HA-SE-CC/W (Wall Mount)
IA-SE-CC IA-SE-CC/W (Wall Mount)
Cleveland Standard Features
I Floor or wall mounting models (please specify)
I Variable mixer speed control
I Mixer start/stop button
I Solid state temperature control with digital read-out
I Time/Temperature Chart Recorder to provide permanent
record of Batch Processing
I Control for automatic and manual steam
I Control for automatic and manual water cooling
I Simmer control for delicate products
I Automatic water meter with accumulative “add on” button
and digital readout (for cold water only)
I All stainless steel construction
I Type 4X rating
I U.L. Listed
I Accepted for use in U.S.D.A. Inspected Facilities
Options & Accessories
Ë Lockable cover over controls
Ë
Water meter for hot and cold kettle fill
Ë Computer interface connections
Shall be Cleveland Model _____-SE-____, COOK/CHILL CONTROL
CENTER with single controls as follows; Solid State Temperature
Control with Digital Read-Out; Time/Temperature Chart Recorder;
Controls for Automatic and Manual Water Cooling; Simmer
Control; Automatic Water Meter with accumulative “add on” button
and digital readout; Variable Mixer Speed Control and Mixer
Start/Stop Button.
Short Form Specifications
Model HA-SE-CC shown
SECT. XIV PAGE 16
0609
Litho in USA
Cleveland Range reserves right of design improvement or modification, as warranted.
24"
69"
15"
1
8 3/4"
51"
18"
AFF
W
ALL MOUNTED
CONTROL PANEL
HEIGHT DIMENSION
INVERTERS ARE
EXTERNIALY MOUNTED
FOR WALL MOUNTED
CONTROL PANELS
PLAN VIEW
FRONT VIEW
SINGLE CONTROL PANEL
MINIMUM CLEARANCE
FRONT 36"
SIDE 12"
REAR 0"
MODEL ELECTRICAL
HA-SE-CC (floor mount)
HA-SE-CC/W (wall mount)
IA-SE-CC (floor mount)
IA-SE-CC/W (wall mount)
THE DEPTH AND WIDTH DIMENSIONS ARE THE SAME
FOR BOTH THE FLOOR MOUNT AND WALL MOUNT
CONTROL PANELS.
AMPERAGE
BASED ON
KETTLE SIZE
208V/
3PH/60Hz
ELECTRICAL POWER TO AND FROM CONTROL PANEL
CONTRACTOR MUST CUT ENTRY HOLE
TOP OR BOTTOM POWER ENTRY RECOMMENDED
MUST USE PROPER CONNECTIONS TO MAINTAIN
U.L. LISTING
(NOT TO SCALE)
  • Page 1 1
  • Page 2 2

Cleveland Range IA-SE-CC Datasheet

Category
Wall & ceiling mounts accessories
Type
Datasheet
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI