Extron SF 10C SUB Template

Type
Template

This manual is also suitable for

Red solid lines are die cut.
Template Material Thickness = 0.015” (0.38 mm)
Black Ink
Finished size = 7.6” (193 mm) ceiling cutout diameter
68-2845-50 Rev. A
09 15
Important Note: Print 1:1 only.
Do not scale.
7.6" (193 mm) cutout diameter
Center hole = 0.375” (9.5 mm) diameter
SF 3C LP and
SF 3CT LP
1. Mark the location where the speaker
will be centered and installed.
2. Align the center hole of the template
with the mark.
3. Trace a circle around the cutout template.
4. Cut out the traced circle.
Cutout Template Instructions
Cutout Template
  • Page 1 1

Extron SF 10C SUB Template

Type
Template
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI