FläktGroup eQ Exchange panel Installation and Maintenance Manual

Type
Installation and Maintenance Manual
FläktGroup DC_8675GB 20180228_R0 Specifications are subject to alteration without notice
Pull off the sealing strip seated on the outside of the unit at both
ends of the panel that you are replacing.
Remove all the screws that secure the panel that you are
replacing.
Then remove the panel. If there are two panels next to one
another, you can remove them by prising them loose from
underneath. N.B.! Do not prise them loose from the side as doing
so may damage adjacent panels.
EQ EXCHANGE PANEL
INSTALLATION AND MAINTENANCE INSTRUCTIONS
Warning!
Do not enter the air handling unit when you are
replacing panels.
Warning!
In the frameless casing version, the panel is a
supporting part of the structure
Before you begin replacing the panel, you must
sufficiently brace the roof and/or intermediate
floor with a secure stay that will carry the
load of the functional components in the upper
level of the unit. Read the code on the unit
identification plate to determine whether or not
the casing is frameless.
2
Installation and maintenance instructions
FläktGroup DC_8675GB 20180228_R0 Specifications are subject to alteration without notice
Sealing strip on
both sides
New panel
Be very exact about fitting the sealing strip correctly:
Sealing strip on the front part.
Panel 1 and 2:
Sealing strip on the rear part.
Panel 1, 2.
Be very exact about fitting the
sealing strips correctly.
Push the panel into position and
tighten its fixing screws.
  • Page 1 1
  • Page 2 2

FläktGroup eQ Exchange panel Installation and Maintenance Manual

Type
Installation and Maintenance Manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI