MULTIPLEX MD-175 Medallion Replacement (IN-SV04-03) Installation guide

Type
Installation guide

This manual is also suitable for

IN-SV04-03
REV 05/14/04
If you have any questions concerning this bulletin, please contact Manitowoc Beverage Equipment’s Technical Service Department at (800) 367-4233
Foodservice Group
MD-175
Duratran/Medallion Replacement
FIGURE 1
Knurl Screws
1
FIGURE 2 FIGURE 3
1. Disconnect power to the dispenser.
2. Remove full lid or manual fill lid from unit.
3. Remove the 2 Knurl screws from top of merchandiser.
(See figure 1)
4. Remove the merchandiser from the unit by pulling the top
of the merchandiser up and forward then push the mer-
chandiser upward to release from unit. (See Figure 2)
Note: The Merchandiser for the MD-175 consist of three
parts that push together - (Merch Top, Merch Bottom,
and the center is the medallion. (See figure 5)
5. Pull the top of the merchandiser from the Medallion.
(See Figure 3)
Tools Required
z Flat head screw driver
IN-SV04-03
REV 05/14/04
If you have any questions concerning this bulletin, please contact Manitowoc Beverage Equipment’s Technical Service Department at (800) 367-4233
Foodservice Group
MD-175
Duratran/Medallion Replacement
FIGURE 4
FIGURE 5
Medallion
Merchandiser Top
Merchandiser Bottom
6. Pull the bottom of the merchandiser from the Medallion.
(See figure 4)
7. The Medallion should now be loose and can be disposed
of. (See Figure 5)
8. Next attach the top and bottom of merchandiser to new
Medallion in reverse of steps 6 & 7.
9. Replace the merchandiser and manual fill lid (or full lid)
back to dispenser in reverse order. Be sure to secure the
manual fill lid and merchandiser with the two knurl screws.
10. Reconnect power to the dispenser.
  • Page 1 1
  • Page 2 2

MULTIPLEX MD-175 Medallion Replacement (IN-SV04-03) Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI