2. Detecto
  3. EH Floor Scale

Detecto EH Floor Scale Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Detecto EH Floor Scale Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Echelon EH Series Floor Scale Set-up
1930-0490-0M Rev A
03/16
1
EH-544 / EH-1044
Economy Floor Scale
1
Locate box of feet in carton on underside of scale.
3
Remove the two screws and scale side cover from scale.
4
Remove junction box from scale.
2
Screw foot into load cell at each corner.
Echelon EH Series
Floor Scale Set-up
1930-0490-0M Rev A
03/16
Echelon EH Series Floor Scale Set-up
2
7
Route indicator cable through the scale side cover.
5
Remove the four screws and cover of the junction box.
6
Remove indicator cable wires from terminal block.
Note location of wires:
- EXE Black
- SIG White
SHIELD May be any color
+ SIG Green
+ EXE Red
Echelon EH Series Floor Scale Set-up
1930-0490-0M Rev A
03/16
3
Scale is now ready to connect to digital weight indicator and calibrate.
8
Re-connect indicator cable wires to terminal block in junction box.
Ensure wires are reconnected to the proper terminals.
Note location of wires:
- EXE Black
- SIG White
SHIELD May be any color
+ SIG Green
+ EXE Red
10
Place junction box in scale and re-install side cover.
9
Replace cover on junction box and secure with four screws.
/