2. ITC
  3. Shoul Underwater Light
Shoul Underwater Light

ITC Shoul Underwater Light Installation guide

  • Hello! I've reviewed the installation instructions for the ITC Underwater Light 6968X-KKKK. This guide details how to properly install the underwater light, including wiring and mounting procedures. The document includes two wiring diagrams for RGBW controllers and 3-position switches, along with important electrical specifications and safety considerations. I'm ready to help you with any questions you have about installing your underwater light.
  • What is the input voltage for the SHOUL lights?
    What is the maximum wattage of the Standard SHOUL light?
    What is the maximum current of the Mini SHOUL light?
    What size hole is needed for the wiring?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
Safety/Installation Considerations
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Lights are designed for underwater usage only.
• Electrical Specs:
Standard SHOUL - Input voltage: 10-24V DC| Max Wattage: 60W | Max Current: 5A @ 12V
Mini SHOUL - Input voltage: 10-24V DC| Max Wattage: 16W | Max Current: 1.12A @ 12V
• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
1. Determine the installation location and drill a 1/2” hole for the wiring. Wire to the boats power using the
wiring diagram below.
PARTS / TOOLS NEEDED:
Underwater Light
RGBW Controller or
3-Position Switch
(not provided)
Mounting Screws Power Drill Marine Grade Sealant
(not provided)
Marine Grade Splices
(not provided)
2. Install light using included screws. Make sure to seal around the outside perimeter of the light using a
marine grade sealant.
INSTALLATION INSTRUCTIONS
Shoul™ Underwater
Light
Part#: 6968X-KKKK
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00185 • Rev D • 08/24/22
Page 1 of 2
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
3. Wiring Diagram
Negative (-)
RGB(W)
Controller
Positive (+)
Incoming
10V - 24V
Power
Green (G) (-)
White/Red (+)*
Underwater
Light
Red (R) (-)
Blue (B) (-)
White (W) (-)
Negative (-)
Positive (+)
Negative (-)
3-Position
Switch
Incoming
10V - 24V
Power
Underwater
Light
Blue (B) (-)
White (W) (-)
Negative (-)
Positive (+)
RGBW Wiring
Blue/White Two Color Wiring
*Note, there will be an extra white/red wire on the RGB(W) controller that should be capped. On the underwater light, any unused
colors should be capped or connected to the V+ line. For example, if using a RGB controller, the white (W) wire from the underwa-
ter light should be capped or connected to the V+ line. Underwater Light Wire Gauges : Positive (+)/ Negative (-) - 18AWG RGBW
- 24AWG (Signal wires only <0.1A)
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00185 • Rev D • 08/24/22
Page 2 of 2
/