FB23208F
Jeep® JL Wrangler & JT Gladiator
JL & JT Front Steel Tube Fenders
23208F00
REQUIRED TOOLS
5mm Allen
Note: These instructions will NOT
cover how to remove factory
fenders or inner fenders, and will
NOT cover how to install inner
fenders. Instructions on how to
do so are available on
www.FishboneOffroad.com , or
www.FishboneOffroad.tv .
KIT CONTAINS
Front Fender (Left & Right)
LED Turn Signal
Rubber Seal
M8 Button Head Bolt
M8 Flat Washer
M8 Serrated Nut
QTY
2
2
2
24
24
24
FB23208F
Jeep® JL Wrangler & JT Gladiator
JL & JT Front Steel Tube Fenders
1 23208F00
1) REMOVE
Begin by removing any inner and outer fenders your
vehicle currently has installed.
2) PREPARE
The included rubber seals are driver and passenger
side specific. Identify which side is which by the
bolt hole indents in the rubber. Peel off the backing
and carefully apply the seal to the vehicle side wall
of each fender.
Install the included LED lights into their slots. Start
by pulling the rubber seals off the lights, and firmly
pushing them into the fender holes.
Pull the lights through and seat them into the seals
so that the amber LED is furthest away from the
vehicle, when right side up. Push the male
connecting wires through the housing brackets/ and
connect the amber light to blue, and the white LED
to red, followed by the black and white wires to
either ground connector.
FB23208F
Jeep® JL Wrangler & JT Gladiator
JL & JT Front Steel Tube Fenders
2 23208F00
3) INSTALL FRONT FENDERS
Hold the corresponding fender up to the vehicle
and begin loosely securing it with 12 of the included
M8 bolts, washers, and serrated nuts.
Connect the turn signal’s power to the vehicle and
begin tightening the bolts using a 5mm Allen key.
Remove the tape backing on the power converter
and secure it to your vehicle as desired.
Repeat on the opposite side
4) ENJOY YOUR NEW FISHBONE OFFROAD JL & JT
FRONT FENDERS
/
