Omega iTCX-W Owner's manual

ADDENDUM FOR iTCX-W

These changes are the result of the following product enhancement:

New case mounting design.

This addendum applies to Part 2 Hardware in your iServer Operator’s

Manual.

2.1 Wall Mounting

Position unit where required. Mark and drill the two #4 screw holes.

After bracket is mounted on the wall, align back of unit over the three

bracket clips, once engaged, slide downward, the unit will snap in place.

Dimensions are in

inches with

millimeters in [ ].

1.50 [38.1]0.52 [13.3]

1.26 [32.1]

DRILL 0.125 [3.17]

USE TWO, #4

FLAT HEAD SCREWS

TO MOUNT BRACKET

BRACKET CLIPS (3)

SNAP

Figure 2.1 - Mounting Bracket

M4324A/1107

Figure 2.2 Dimensions