2. Troy-Bilt
  3. 21D65M8711
21D65M8711

Troy-Bilt 21D65M8711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 21D65M8711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How to attach the upper handle and handle support brackets to the lower handle?
    How to connect the cables to the upper handle bracket?
    How to connect the cables to the levers and bail?
    How to prepare the device before starting?
    How to start the engine?
    How to adjust the choke after starting the engine?
Red
Black
Red
Black
778-11934B© 2011 21D-65M8
A. Insert the red cable Z-fitting into the hole
in the Reverse Clutch Lever.
B. Insert the black cable Z-fitting into the
hole in the Forward Clutch Bail.
A. Snap the red cable connector into upper
hole in cable bracket.
B. Snap the black cable connector into
lower hole in cable bracket.
Reverse Clutch Lever
Forward
Clutch Cable
Reverse Clutch
Cable
Lower Handle
Forward Clutch Bail
Upper Handle
Handle Support
Brackets
A
B
Tools Required:
• Two/-inch wrenches (or adjustable wrenches)
Remove the hardware from the lower handle
and support brackets.
Loosely attach
the lower handle
to the upper handle
using two 1.5” hex screws
and flange lock nuts.
Do not tighten hardware.
Attach upper handle and
handle support brackets
to lower handle using
the 6.75” carriage bolt,
bell washer and knob.
Tighten all hardware
attached in Step 1
and Step 2.
A
B
Unroll the cables and feed them along the
front of the lower right handle and behind
the handle panel.
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
778-11934B© 2011 21D-65M8
Gas Cap
Throttle
Control
Starter Rope
Handle
Choke
Control
Oil Fill
Fill fuel tank with clean, fresh
gasoline until fuel reaches the fuel
level indicator.
Pour the entire contents of the
oil bottle (included in carton)
into the oil fill.
Grasp starter rope handle
and pull with quick, full-arm stroke.
When engine starts, slowly move choke
control into the Run position.
Move throttle control into the
Fast position.
Move the choke control
into the Choke position.
7
10
8
11
9
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
/