Hagerco 3400 Series Lever - Grade 1 Cylindrical Lever Operating instructions

Type
Operating instructions
Rev -, Rev Date: 02/07/2019 27390104 Page 1 of 2
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
SFIC TIMING INSTRUCTIONS
3470 CLASSROOM & 3473 CORRIDOR
I-LS02384
DOOR HANDING: RH/RHR
STEP 1: Using a flat blade screwdriver, orient the cam in the lock chassis as shown below
3470 EXTERIOR
INTERIOR
EXTERIOR
STEP 2: Orient the tailpieces in the mating spring cages to match the cams above. Install the exterior spring cage first, followed by the
interior spring cage, lining up the cams and tailpieces so they mate together. Do not force the fit.
SFIC FORKS MUST BE
ORIENTED AS SHOWN
STEP 3: Install SFIC Core in lever
VERIFY INSTALLATION: Using the keys, check the lock timing. The lock is properly timed if the key rotates 360° to lock and unlock the door.
FINGER SHOULD BE
VISIBLE AS SHOWN
3473 EXTERIOR
Rev -, Rev Date: 02/07/2019 27390104 Page 2 of 2
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
SFIC TIMING INSTRUCTIONS
3470 CLASSROOM & 3473 CORRIDOR
I-LS02384
DOOR HANDING: LH/LHR
STEP 1: Using a flat blade screwdriver, orient the cam in the lock chassis as shown below
EXTERIOR
FINGER SHOULD BE
VISIBLE AS SHOWN
3470 EXTERIOR
STEP 2: Orient the tailpieces in the mating spring cages to match the cams above. Install the exterior spring cage first, followed by the
interior spring cage, lining up the cams and tailpieces so they mate together. Do not force the fit.
STEP 3: Install SFIC Core in lever
VERIFY INSTALLATION: Using the keys, check the lock timing. The lock is properly timed if the key rotates 360° to lock and unlock the door.
3473 EXTERIOR
SFIC FORKS MUST BE
ORIENTED AS SHOWN
  • Page 1 1
  • Page 2 2

Hagerco 3400 Series Lever - Grade 1 Cylindrical Lever Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI