Concept VS-5013 User manual

Page is loading ...

EN

17VS5013

ThankyouforpurchasingaConceptproduct.Wehopeyouwillbesatisedwithourproductthroughoutitsservicelife.

Pleasereadthewholeinstructionmanualcarefullybeforeyouusetheapplianceforthersttime;afterreading,store

andkeeptheinstructionmanualinasafeandhandyplace.Makesurethatallotherpeopleusingtheapplianceare

familiar with the instruction manual.

ACKNOWLEDGMENT

IMPORTANT SAFETY PRECAUTIONS:

• Donotusetheunitdierentlythandescribedinthismanual.

• Removeallpackingandmarketingmaterialfromtheunitbeforeyouuseitforthersttime.

• Verifythatthemainsvoltagecorrespondswiththevaluesindicatedontheunitlabel.

• Placetheunitonastablesurface,awayfromothersourcesofheat.

• Donotleavetheunitunattendedwhileitisturnedonorpluggedintothepowersupplysocket.

• Whenplugging andunplugging the unit into and from thesocket, the mode selector must be in the 0 (o)

position.

• Neverholdthepowercordwhendisconnectingtheunitfromthesocket;graspandpulltheplug,notthecord.

• Donotallowchildrenorlegallyincapacitatedpeopletohandletheunit;theappliancemustbeusedoutofreach

of such persons.

• Anyphysicallychallengedpersons,personswithreducedsensoryperceptionorinsucientmentalcapacity,or

persons who have not been familiarized with the operation may only use the unit under the supervision of a

responsible, instructed person.

• Exerciseutmostcautionwhenusingtheunitwhilechildrenarenearby.

• Preventtheunitfrombeingusedasatoy.

• Neverinsertngers,pencils,oranyotheritemsthroughthemeshprotectionofthefan.

• Neverusethefanwiththeprotectivemeshremoved.

• Donotexposechildrenorillpeopletodirectairow.

• Donotcovertheunit.

• Donothanganythingaboveorinfrontoftheunit.

• Theunitmaybeoperatedintheuprightpositiononly.

• Donotusetheunitnearashower,bathtub,sink,orswimmingpool.

• Donotusetheunitinawetordustyenvironment.

• Do not use the unit in an environment where explosive gases or ammable substances (solvents, varnishes,

adhesives, etc) are present.

• Pull the power cord out of the socket before assembly or disassembly of the unit.

• Switch the unit oﬀ and pull the plug from the socket prior to cleaning and after use of the unit.

• Keeptheunitclean;preventforeignbodiesfromenteringthemeshopenings.Thesecouldcauseseriousinjury,

shortcircuit,damageorreoftheunit.

• Donotuseabrasiveorchemicallyaggressivesubstancestocleantheunit.

Technical parameters

Voltage 220–240 V ~ 50 Hz

Input 50 W

Noise level 52 dB (A)

EN

18 VS5013

1.Thisapplianceisnotintendedforusebypersons(includingchildren)withreducedphysical,sensoryormental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction

concerninguseoftheappliancesbyapersonresponsiblefortheirsafety.

2. Children should be supervised to ensure that they do not play with the appliance.

• Neverusetheunitifthepowersupplycordorplugisdamaged.Haveanydefectsimmediatelyrepairedbyan

authorized service center.

• Donotusetheunitifitdoesnotoperateproperly,orifithasbeendropped,damagedorexposedtoliquid.Take

theunittoanauthorizedservicecenterfortestingandrepair.

• Theunitisnotdesignedforoutdooruse.

• Theunitisintendedforhouseholduseonly;itisnotdesignedforcommercialapplication.

• Donottouchtheunitifyourhandsarewet.

• Do not immerse the power cord, plug, or unit in water or any other liquid.

• Donotattempttorepairtheunitbyyourself.Contactanauthorizedservicecenterforrepair.

Failure to follow the manufacturer‘s instructions may lead to refusal of warranty repair.

PRODUCT DESCRIPTION

1. Front wire mesh

2. Nut

3. Fan

4. Mesh attachment nut

5. Rear wire mesh

6. Unit body

7. Telescopic support

8. Plastic hood

9. Upper part of stand

10. Lower part of stand

11. Mode selector

12. Stand nut

13. Oscillation selector

14. Fastening ring

15. Fixing screw

1

14

11

7

12

8

13

15

9

10

2 4 5 63

EN

19VS5013

ASSEMBLY

ATTENTION!

Pullthepowercordoutofthesocketbeforeassemblingordisassemblingtheunit.

The fan may only be used with the front and rear protective mesh attached (1), (5).

1.Usingparts(9,10),assemblethestandsupport.Usefourscrews(included)toattachthetelescopicsupport(7).

 Usetheplastichood(8)tocovertheconnection.

2.Mounttheunitbodyunitontothesupportstand,usexingscrew(15)toxtheassembly.

3. Position the rear protective mesh (5) onto the drive unit so that the pins on the unit correspond with the holes in the

mesh.

Usetheattachmentnut(4)tosecuretheassembly.

4.Slidethefan(3)ontothemotorshaftbypositioningthegroovesinthefanhubagainsttheshafttongues.

5. Turn the nut (2) counter-clockwise to fasten the fan.

6.Positionthefrontwiremeshontotherearmeshandslideonthefasteningring(14)sothat

themeshedgestintothegroovesontheinsideofthering.

7.Tightenthefasteningringwiththescrew.

OPERATING INSTRUCTIONS

Priortousingtheunitverifythepowercordisintact.

1. Placetheunitontheoorsecurelysoitcannottipover.

2. Uncoilthepowercord.

3. Tiltthefanasrequired(Fig.1).Youwillhearseveralclicksthatlockthefaninindividualpositions.

4. Adjustthedesiredheightofthefanbylooseningthestandnut(12)andextendingthetelescopicsupport(7)(Fig.2).

5. Connectthepowercordplugtothewallsocket.

6. Usethemodeselectortochoosetherequiredspeed–

0 – OFF, 1 – LOW, 2 – MEDIUM, 3 – HIGH.

7. Toturnfanoscillationowhiletheunitisrunning,pullouttheoscillationselector(Fig.3t).Pushingtheselectorinturns

oscillation on.

8.Afteruse,turnthemodeselectorto0andunplugtheunitfromthemains.

Fig.1 Fig.2 Fig.3

EN

20 VS5013

SERVICING

Anyextensivemaintenanceorrepairthatrequiresaccesstotheinnerpartsoftheproductmustbeperformedbyanexpert

service centre.

ENVIRONMENTAL PROTECTION

• Packagingmaterialsandobsoleteappliancesshouldberecycled.

• Thetransportboxmaybedisposedofassortedwaste.

• Polyethylenebagsshallbehandedoverforrecycling.

Appliance recycling at the end of its service life:

Asymbolontheproductoritspackagingindicatesthatthisproductshouldnotgointohouseholdwaste.

Itmustbetakentothecollectionpointofanelectricandelectronicequipmentrecyclingfacility.Bymaking

surethisproductisdisposedofproperly,youwillhelppreventthenegativeeectsontheenvironmentand

humanhealththatwouldotherwiseresultfrominappropriatedisposalofthisproduct.Youcanlearnmore

aboutrecyclingthisproductfromyourlocalauthorities,ahouseholdwastedisposalserviceorintheshop

whereyouboughtthisproduct.

CLEANING AND MAINTENANCE

Attention!

Alwaysdisconnectthepowercordfromthesocketbeforecleaningtheunit!

Thesurfaceoftheunitmayonlybecleanedwithawetcloth.Donotuseanydetergentsorhardobjectsastheymay

damagethesurfaceoftheunit!

Thefrontandrearwiremeshshouldbecleanedfrequentlytoensureproperoperationoftheunit.

Never clean the unit under running water; do not rinse or immerse it in water!

The fan disassembly procedure follows the reverse order of the assembly.

Page is loading ...

Jindřich Valenta - ELKO Valenta Czech Republic, Vysokomýtská 1800,

565 01 Choceň, Tel. +420 465 322 895, Fax: +420 465 473 304, www.my-concept.cz

ELKO Valenta – Slovakia, s.r.o., Hurbanova 1563/23, 911 01 Trenčín

Tel.: +421 326 583 465, Fax: +421 326 583 466, www.my-concept.sk

Elko Valenta Polska Sp. Z. o. o., Ostrowskiego 30, 53-238 Wroclaw

Tel.: +48 71 339 04 44, Fax: 71 339 04 14, www.my-concept.pl

Concept VS-5013 User manual

Related papers

Other documents