Signature Hardware 247757 Installation guide

247757
Signature Hardware
Brand
Signature Hardware
Model
247757
Type
Installation guide
Shelf Bracket Installation Instructions 1
1. Attach your shelf bracket(s) to the bottom of the shelf that
you are mounting using the provided screws. Ensure that each
bracket is properly aligned before attaching.
Important: Not all shelf materials can be drilled into. If your
shelf is made of a fragile material, use a proper adhesive.
SHELF BRACKET INSTALLATION
INSTRUCTIONS
TOOLS AND MATERIALS:
Unpack and inspect the product for shipping
damage. If any damage is found, contact
Customer Relations at 1.866.855.2284.
BEFORE INSTALLING INSTALLATION
We recommend consulting a professional if
you are unfamiliar with installing this type of
hardware. Signature Hardware accepts no
liability for any damage to the bracket, shelf,
wall, or personal injury during installation.
Observe all local building codes.
Screwdriver
Drill
Level
Pencil
Stud Finder
2. Locate where you wish to hang your shelf. Use a stud finder
to locate a stud behind your wall.
drywall stud
stud
finder
GETTING STARTED
Ensure that you have gathered all the
required materials that are needed for
installation.
2
3. While holding the shelf against the wall, adjust it until
it is level. Once the shelf is properly aligned, use a pencil
to mark the location of each mounting hole on the wall.
Have someone assist you if needed.
4. Drill small pilot holes in the marked locations from
step 3.
5. Attach the bracket(s) to the wall using the
provided mounting screws. Be careful not to
overtighten, which could strip or break the screw.
Shelf Bracket Installation Instructions
SHELF BRACKET INSTALLATION
  • Page 1 1
  • Page 2 2

Signature Hardware 247757 Installation guide

247757
Signature Hardware
Brand
Signature Hardware
Model
247757
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents