29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
Installation Manual
Specifications
Type of controller: RGBW Remote control Remote size (mm): (L) 136.3mm x (W) 38.9mm x (D) 10.7mm
Protocol: RF + Bluetooth Transmission frequency: 2.4GHz
Dimming range: 0.1% - 100% Transmission range: 30m
Remote colour: Black Operation voltage: 3VDC (CR2025)
Note: -The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
CHAM-REM-3C Date: February 1, 2023 2:02 PM
Variants Item No. Details
20142 CHAM-REM-3C RGBW Remote
Thank you for purchasing your new CHAM-REM-3C Remote control, Please take the time to read and understand the instruction
sheet below. Failure to do so may void warranty.
• RF+Bluetooth RGBW remote control
• Enables to control 4 zones of receivers
• Easy & quick pairing to the RF+Bluetooth receivers by simply pushing the buttons
• Mesh network for further control distance, receivers can transmit signal to each other
• Each remote can control numerous receivers
• Each receiver can be paired to max. 8 remote controls
• The controlled receiver status can be quickly synchronised to the smart APP
• Transmission range between every two neighbour devices up to 30m
• Bluetooth low power consumption technology, long battery life
• With magnet on the back, easy fasten to & remove from the bracket
• Waterproof grade: IP20
Safety & Warnings
• This device contains lithium battery that shall
be stored and disposed properly.
• DO NOT expose the device to moisture.
Brightness up button, press and hold down
to increase light intensity.
RGB color button, press and hold down to
get the color you would like.
On/Off Button
Click to turn on/off W channel, press and
hold down to increase/decrease light
intensity of W channel
Scene button, press and hold down to save
a scene, click to recall the saved
Brightness down button, press and hold
down to decrease light intensity.
1 RGB color changing mode, click to play/
pause the mode, press and hold down to
speed up/down the mode.
Zone buttons,
click to choose a zone.
Pair with RF+Bluetooth receiver
Step 1: Do wiring the receiver according to wiring diagram (please refer to the instruction
of RF receiver that you would like to pair with).
Step 2: Click the “Prog. Key” or “Reset” button on RF+Bluetooth receiver (or reset power
of the receiver 3 times continuously if the button is not accessible) to set it into pairing to RF
remote status
Step 4: Then immediately click any other button except zone buttons, LED lights connected
with the receiver flicker once means the receiver is paired with zone successfully.
Step 3: Click a zone button to select a zone (e.g. zone 2).
Note: one receiver can be paired with max 8 remote controls.
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Option 2: have all the receivers in different zones, like zone 1, zone 2, zone 3 and zone 4
RF+Bluetooth LED Receiver
Prog
