2. Barco
  3. MDRC-2122 Option TS black
MDRC-2122 Option TS black

Barco MDRC-2122 Option TS black, Eonis 22" (MDRC-2122 WP), Eonis 22" (MDRC-2122, Option BL), Eonis 22" (MDRC-2122, Option TS), Eonis 22" (MDRC-2122, Option WP) Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Barco MDRC-2122 Option TS black Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation instructions
K5903076-00
Install a MDRC-2122 on a VESA arm
To remove the display from the stand:
The display panel, standard attached to a stand, is compatible with the VESA 75 mm standard.
1. Put the display face down on a clean and soft surface. Be carefull not to damage the panel.
2. While supporting the foot with one hand, unscrew the 4 screws fixing the foot.
3. Remove the foot.
4. Remove the vesa cover of the foot. Push the clip at the rear bottom side of the cover while
pulling it down. Pull the cover upwards. Turn around the cover and put it back at the display as
shown in the drawings below.
2
To mount the vesa arm:
1. Remove the display from the stand as described in previous chapter.
2. Use 4 M4 screws to attach the panel to the VESA arm. Please make sure that the length of the
screws is 25 mm.
3. Plug the power cable in the power connector of the display panel. Attach the other side of the
cable to the power cable of the VESA arm.
/