2. RealWheels
  3. Tail Light Guards

RealWheels Tail Light Guards Installation guide

  • Hello! I've reviewed the installation instructions for the stainless steel tail light armor designed for the 2007 Jeep Wrangler. This document outlines a straightforward process involving removing the existing screws, using new screws with spacers to affix the armor, and tightening them securely. The kit includes all necessary hardware, and the instructions should help you protect your Jeep's tail lights with ease. I'm ready to answer any questions you have about this process, or the product itself.
  • Are the original tail light screws used in this installation?
    What size screws are used for the bottom holes?
    Are spacers used during the installation?
PHOTO 1 PHOTO 2 PHOTO 3
PHOTO 4 PHOTO 6
Now using the new screws (provided), insert the
larger screw (#8) through the outside top hole and
through the spacer (provided). Insert the smaller
screw (#6) through the inside top hole and through
the spacer.
Now securely tighten all four screws. Repeat for the
other side and you are finished.
Begin by removing all four screws from the tail light.
You will not use these screws for installation.
Using the new screws (provided), insert the larger
screw (#8) through the outside bottom hole and the
smaller screw (#6) through the inside bottom hole.
Then place the spacers (provided) on each screw.
Place the Tail Light Armor in position and loosely tight-
en the two bottom screws.
INSTRUCTIONS FOR 2007 JEEP WRANGLER
IMPORTANT: Read And Understand All Instructions Before Installation • QUESTIONS? CALL 1-800-982-1180
RealWheels Cover Company, Inc. • 3940 Tannahill Drive • Gurnee, IL 60031
847-662-7722 • Fax 847-662-7744 • www.realwheels.com • [email protected] • toll-free 1-800-982-1180
Jeep is a
registered trademark of
Chrysler LLC
and is used for identification purposes only.
RealWheels Cover Company, Inc. and its products are not affiliated with
Chrysler LLC,
Jeep or any of Chrysler's affiliated companies.
Copyright ©2007 RealWheels Cover Company, Inc. All Rights Reserved.
Form J-7 10/11/07
STAINLESS STEEL TAIL LIGHT ARMOR Time To Install: Approx. 15 Minutes
PHOTO 5
Larger Screw
Larger Screw
Smaller Screw
Smaller Screw
Smaller
Screw
Smaller
Screw
Larger Screw
Larger Screw
PHOTO 7
/