RealWheels Rear Tow Hook Covers Installation guide

Type
Installation guide
INSTRUCTIONS FOR JEEP WRANGLER JK
IMPORTANT: Read And Understand All Instructions Before Installation QUESTIONS? CALL 1-800-982-1180
TOW HOOKS Time To Install: Approx. 30 minutes
Tool Needed: 7/64” and 1/16” Allen Keys
4. Now insert the small supplied set screw through
the inner portion of the tow hook and tighten.
Repeat for the opposite side and you’re finished!
PHOTO 1
PHOTO 2 PHOTO 4A
PHOTO 3A PHOTO 3B
PHOTO 4B
1. Begin by placing the top half of the tow
hook cover over the factory tow hook.
3. Insert all three screws (See Photo 3A), and tighten using a 7/64” allen key (See Photo 3B).
2. Place the bottom half of the tow hook cover
over the factory tow hook and align the screw holes.
4. Next tighten up the center set screw by using a 1/16” allen key (See Photo 4A). And you’re finished
(See Photo 4B)
REAR TOW HOOK
PHOTO 1
PHOTO 2 PHOTO 4
PHOTO 3A PHOTO 3B
1. Begin by placing one half of the tow hook
cover over the factory tow hook.
3. Now insert all three screws through the tow hooks (See Photo 3A), and tighten the screws using a 7/64”
allen key (See Photo 3B).
2. Place the other side over the factory tow hook.
FRONT TOW HOOKS
RealWheels Corporation • 3940 Tannahill Drive • Gurnee, IL 60031
847-662-7722 • Fax 847-662-7744 • www.realwheels.com • [email protected]toll-free 1-800-982-1180
Jeep is a registered trademark of Chrysler LLC and is used for identification purposes only.
RealWheels Corporation and its products are not affiliated with Chrysler LLC,
Jeep or any of Chrysler's affiliated companies.
Copyright ©2008 RealWheels Corporation. All Rights Reserved.
Form J-18 2/20/08
  • Page 1 1

RealWheels Rear Tow Hook Covers Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI