RealWheels Side Mirror Surrounds Installation guide

INSTRUCTIONS FOR 2007 JEEP WRANGLER

IMPORTANT: Read And Understand All Instructions Before Installation • QUESTIONS? CALL 1-800-982-1180

RealWheels Corporation • 3940 Tannahill Drive • Gurnee, IL 60031

847-662-7722 • Fax 847-662-7744 • www.realwheels.com • [email protected] • toll-free 1-800-982-1180

Jeep is a registered trademark of Chrysler LLC and is used for identification purposes only.

RealWheels Corporation and its products are not affiliated with Chrysler LLC,

Jeep or any of Chrysler's affiliated companies.

Form J-12 10/12/07

BILLET SIDE MIRROR SURROUNDS Time To Install: Approx. 20 Minutes

PHOTO 1 PHOTO 2A PHOTO 2B

PHOTO 3 PHOTO 4A PHOTO 4B

1. Extremely Important: Clean the

area where the Side Mirror Surround is to

be installed. If the area where the trim accessory is

to be installed is not clean, dry, and free of any vinyl

dressing, the trim accessory piece will not stick in

place. Begin by cleaning the area thoroughly with a

good non-residue cleaner such as Windex, or just clean

thoroughly with soap and water and dry completely.

2. Using a T-40 Torx Bit, remove the mirror from its base. (See photos 2A & 2B)

4. Using a T-40 Torx Bit, re-install the mirror to its

base. (See Photos 4A & 4B) Repeat for the other side

and you are finished. (See Photo 4C)

Tool Needed: T-40 Torx Bit

3. Position and Adhere the Mirror

Surround. Before removing any heavy duty 3M Tape

backing from the Trim Piece, loosely place it in position

to verify how it will fit. Make sure the part lines up with

any openings and fits side-to-side and top-to-bottom.

Next peel off all the paper from the double-sided tape

on the back of the Trim Piece. Carefully place the Trim

Piece in position. Push and hold firmly for a few sec-

onds.

PHOTO 4C

Download PDF