ADD Offroad Capture Fairlead System Installation guide

Type
Installation guide
ADD Capture™ Fairlead
Installation Instructions
Addictive Desert Designs® | Page 1
ADDICTIVE DESERT DESIGNS®
®
Preparation:
• Disconnect the negative battery terminal. Park the vehicle on level ground and set the emergency brake.
• We recommend reading through the installation instructions in whole before performing the work.
• Estimated Installation Time: .5 Hour
**If you are already installing a winch, do not add any labor time for this install.**
You will need the following tools:
- Ratchet - 5/16" Allen Wrench/Socket - 3/4" Wrench
- Snap Ring Pliers
Included in Kit:
2 - Button Head Bolts
(1/2”-13 x 1 1/2")
2 - Flat Washers
(1/2”)
2 - Nylon Lock Nuts
(1/2”-13)
1 - Snap Ring
1 - Hook Pin 1 - Capture Hook
1 - Capture Fairlead
Installation:
1. Mount the Fairlead to your bumper using the supplied 1/2" Bolts (x2), 1/2" Washers (x2), and 1/2" Lock Nuts
(x2). Torque these bolts to 70 foot pounds. (Fig A)
Fig A
ADD Capture™ Fairlead
Installation Instructions
Addictive Desert Designs® | Page 2
ADDICTIVE DESERT DESIGNS®
®
2. Slide the end of the winch rope into the hook. en use the Hook Pin to hold the rope in place. Install the
supplied Snap Ring (x1) to secure the hook pin. (Fig B)
Fig B
ADD Capture™ Fairlead
Installation Instructions
Addictive Desert Designs® | Page 3
ADDICTIVE DESERT DESIGNS®
®
3. Stand back and enjoy your new ADD Capture™ Fairlead.
4. Check and re-tighten, if needed, all mounting bolts aer 100 miles and periodically thereaer.
For Additional Support or Technical Questions,
Please Call 480-671-0820 or
Email Info@AddictiveDesertDesigns.com
is product is protected by one or more U.S. patents
www.addictivedesertdesigns.com/patents
  • Page 1 1
  • Page 2 2
  • Page 3 3

ADD Offroad Capture Fairlead System Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI