IMPORTANT! KEEP THE INSTRUCTION FOR FURTHER REFERENCE
706/5165
Important-Please read the instruction fully before starting assembly
If you need help or have further question, call the Customer Helpline 03456 400 800
CUGGL TRAVEL COT GREY
Suitable from birth to 36 months, up to 15kgs
Important-Please read the instruction before assembly and keep it for further reference
-1-
BEFORE ASSEMBLING THIS COT, READ AND UNDERSTAND THE FOLLOWING INSTRUCTIONS
All assembly fittings should always be tightened properly and
that fittings should be checked regularly and retightened as necessary.
-2-
Components If you need help or have further question,
call the Customer Helpline 03456 400 800
Please check if you have all the parts listed below before starting assembly
-3-
Unzip the travel bag and
remove the frame and
mattress.
Place the cot in a vertical
position and open the touch
fasteners to remove the
mattress.
With the cot in folded vertical
position on the floor, pull the
feet apart so that they are
approximately 60cm or
24inches apart. Lift the short
sides of the cot upwards until
they lock into position.
Note: Do not press the center
base of the cot until all sides of
the cot are locked properly.
Now lift the length sides of the
cot upwards until they lock into
position, check that all four
sides have engaged correctly
by pressing down on each arm
at the center. If you have
difficulty locking the sides, lift
the center of the base a little
higher ( around 40cm from
ground) and start the process
again.
-4-
4
Place the mattress in the
travel cot with the padded side
up, align the touch fasteners
on the mattress with those on
the base and press down to
ensure they are stuck
together.
Push the center of the cot
base downwards until it
audibly locks into place.
-5-
Folding the cot
Loosen the fasteners on the back
of mattress and take mattress out
from the travel cot.
Lift the handle in the middle of
the base, and then pull the
handle upwards.
Notice: Ensure to hold the tube of
either side at the bottom while
lifting the handle up.
Lift the side rails slightly(a)
and press the lock in the
middle of the rail(b)
(indicated with arrows).
Hold the lock pressed whilst
gently lowering the side
rail
Ensure that the side rail
disengages on both sides of
the mechanism.
Pull together the 2 support
legs underneath the fabric to
center base as close as
possible to the center
base(d).
(c),
In order to fold travel cot closely,
pull together the 2 supporting
legs underneath the fabric to
the center base as close as
possible.
Make sure the connection
joint is in correct position as
shown, if not, push down the
lock again and turn the lock joint
until it reaches right position.
4
-6-
Repeat this process on the
short sides. Check that all 4
sides have disengaged
properly and then pull the
center of the base, if you have
difficulty unlocking the sides,
try to lift the center of the base
a little higher and start the
process again.
With the upper part of the
travel cot in the closed
position, push all 4 feet
together to fold the travel cot
closely.
Wrap the mattress around the
travel cot tightly with padded
section inside, fasten the
touch fasteners through the
tabs and secure tight. Pull the
travel bag provided over the
travel cot and zip it closely.
If you need help or have further question, call the Customer Helpline 03456 400 800
This product complies with EN716-1&-2:2008+A1:2013
/
