Folding Cot
INSTRUCTION MANUAL
Complies with Australia/New Zealand Standard AS/NZS 2195:2010
IMPORTANT:
Thank you for choosing our product. Please read and understand these instructions before using this
folding cot. If in doubt, please seek help from our Customer Service Team.
Please retain the instructions for future reference.
Images in this manual are representative only. Actual product may vary. The manufacturer reserves the right to change
specifications without prior notice.
SAFETY
THANK YOU FOR CHOOSING OUR PRODUCT. PLEASE TAKE TIME TO READ THE
IMPORTANT SAFETY NOTES BELOW. THIS WILL ENSURE MANY YEARS OF HAPPY AND
SAFE USE. IF IN DOUBT, PLEASE SEEK ASSISTANCE FROM OUR CUSTOMER SERVICE
TEAM.
INCORRECT ASSEMBLY MAY MAKE THE COT UNSAFE. DO NOT USE THIS COT IF ANY
PART IS BROKEN, TORN OR MISSING.
WARNING
WARNING! Be aware of the risk of open fires and other sources of strong heat, such as
electric bar fires, gas fires, etc., in the vicinity of the folding cot.
WARNING! Do not use if any part is broken, torn or missing, and only use spare parts
approved by the manufacturer
WARNING! Do not leave anything in this folding cot or place this folding cot close to
another product, which could provide a foothold or present a danger of suffocation or
strangulation, e.g. strings, blind or curtain cords, dressers, etc.
Never use more than one mattress in this folding cot.
The folding cot, including the top rails and base, should be completely locked before
use. Check that all locking devices are fully engaged before using the folding cot.
Regularly check all assembly fittings are tightened properly and retighten as necessary.
DO NOT use this folding cot if any part is broken, torn or missing.
To prevent injury from folding, use this folding cot only for a child who is unable to climb
on or out of the folding cot.
Do not leave anything in this folding cot (such as toys) that could provide a foothold.
Do not use this folding cot near naked heat sources, bar heaters, open fires or exposed
flames.
Keep this folding cot clear of trailing cables and hanging cords.
Keep medication, strings, elastic, small toys and other small items that a child could
choke on away from this folding cot.
The thickness of the mattress has been specified to ensure that the distance from the
top of the mattress to the top of the lowest side or end will always be at least 500mm.
This will reduce the risk of children falling out of the folding cot.
Ensure the correct assembly of this folding cot before use and only use accessories
recommended by the manufacturer.
Folding cots with padded rims should not be used if the covering material has been
bitten through.
Always check that the assembly of this folding cot is correct and safe.
Do not place more than one child in the cot at the same time.
Do not use this cot with a child who weighs more than 15kg or is taller than 90cms.
WARNING - MATTRESS SIZE
This cot is made to use a mattress which is 730mm wide, 1000mm long
and no more than 25 mm thick.
Using the wrong size mattress may create hazardous gaps that could
result in suffocation or could reduce the side height of the cot which
may result in your child falling out from the cot.
A correct specification mattress has been supplied with this folding
cot. Do not use a mattress other than the one supplied by the
manufacturer. Incorrect mattress can cause death.
1 – PARTS LIST
1 Plastic Corner Brackets 7 Centre Foot
2 Folding Connector 8 Base Rail – long
3 Leg Pole 9 Hinge Bracket
4 Plastic Foot 10 Top Rail - short
5 Base Rail – short 11 Top Rail - long
6 Side Rail Assembly
WARNING
Keep children away when assembling or disassembling this folding cot.
IMPORTANT: A mattress is included with this folding cot – it is specifically designed to suit this
product.
2 - SETTING UP THE FOLDING COT
Unzip and remove the carry bag Fig 1, and
then remove the mattress base by
unfastening the three loop/hook fastenings
straps Fig 2, and take out the folding cot.
Pull apart the tops of the 4 legs as shown in
Fig 3.
Starting with the shorter sides, pull up the Side
Rails with both hands quickly to lock them in
place. (Note that these rails are covered by the
fabric of the cot sides.) Fig 4
Repeat with the two longer sides.
CAUTION: TAKE CARE, AS FINGER PINCHING CAN
OCCUR WHEN LOCKING THE RAILS IN PLACE.
The centre of the cot base must be in a raised
position to allow the rails to lock easily.
Check for the secure engagement of all 4 of
the Folding Connectors by pushing down on
them. Ensure all 4 Connectors have clicked
into place and locked properly.
Push down on the Centre Foot in the middle of
the base until the base lays down flat & it clicks
into place. Fig 5
Place the supplied Rigid Mattress Base into the
folding cot and fix it in place by feeding the
loop/hook fasteners through the slits in the
Folding Cot base and attaching them to the
underside of the base. Fig 6
Note – DO NOT use the Rigid Mattress Base
without it being secured to the Folding Cot.
3 – FOLDING THE FOLDING COT
Release the loop/hook fastening straps that
secure the mattress to the cot and remove the
mattress from the Folding Cot. Pull up on the tab
attached to the Centre Foot to lift it out of
engagement. Pull the base up at least 2/3 of the
way to the top. – Fig 7
Release each Top Rail by lifting the Folding
Connector slightly and squeezing the locking
button on the underside of the Connector, and
then push down so the top rails form a “V”
position. Fig 8
The Side Rails on all 4 sides must go downwards
as shown in Fig 9.
If the side rails do not all fold evenly, lift them up
and repeat previous operations until all 4 sides
are fully folded down evenly. Fig 10
IF THE TOP RAILS DO NOT FOLD – DO NOT FORCE
THEM – LIFT UP THE CONNECTORS AND SQUEEZE
THE BUTTONS AGAIN TO FULLY RELEASE THEM.
Pull all 4 legs into the centre and arrange the
frame and cover properly, so that the rigid base
can be wrapped around it and fastened with its
loop/hook fastenings.
straps – Fig 11. Place back into its carry bag. Fig
12.
4 - CLEANING AND MAINTENANCE
Clean off dust and loose dirt by vacuuming at lowest possible power.
Wipe over with a damp cloth with soap and warm water to remove ingrained dirt.
Check the fabric and padding for any damage from tearing or holes.
WARNING
Use only the mattress supplied by the manufacturer of this folding
cot. Using the wrong size mattress may create hazardous gaps
that could result in suffocation or could reduce the side height of
the cot which may result in your child falling out from the cot.
Use only accessories recommended by the Supplier.
Ensure top rails and base are correctly locked before use.
Do not use the folding cot if any parts are damaged or missing.
Made in China
Manufactured for:
The Warehouse Ltd
26 The Warehouse Way,
Northcote, Auckland.
0800 422 274
/