Argos 604/5540 Assembly Instructions Manual

Oxford - Cot Bed

604/5540

614/5536

Assembly Instructions

- Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400 800

Important – Please read these instructions fully before starting assembly

Dimensions

Width - 143,6cm

Depth - 76.5cm

Height - 98,5cm

Issue 2 - 26/10/16

Do not leave anything in the cot or place the cot close to another product, which could provide a foothold or

present a danger of suffocation, e.g. strings, blind/curtain, cords, etc.

The toddler bed is suitable for children aged from 18 months to 4 years.

and BS 8509:2008 + A1:2011

.

when the child is able to climb out of the cot, the cot shall no longer be used for that child.

,

(63 x 76.5cm)

(45 x 76.5cm)

G

I

H

M4 x 50mm Bolt x 4

Nut x 4

x 20

55mm x 55mm Spacer

J

Washer x 4

D

02

01

A

B

A

B

A

B

A

B

A

B

Fix sides frames to the

headboards

and allen

using bolts

key .

Do not fully tighten bolts at

this stage as side rails

need to be fixed first.

Attention!

Ensure mattress

mark on side

frame is facing inwards, as

shown.

Insert barrel nuts into

the side bars .

.

With help, fix side rails

to the first height position in

the assembled headboards

using bolts

and allen key

Attention!

To the correct

position of the

side rails.

There are three height

positions in the cot for the

base, you will need to lower

the side rails as the baby

grows. Please refer to the

first page - warning section

- for more information.

Attention!

Finish tighten bolts

on side frames

using allen key .

A

B

Make sure not to use

these holes while the

product is built as a

cot.

F

B

E

B

E

B

E

B

E

B

04

05

A

B

04

F

05

E

B

E

03

05

C

01

E

B

E

B

E

B

E

B

E

I

B

J

Make sure

to use the

holes

indicated in

the drawing!

Use the holes indicated in

the drawing, otherwise,

the toddler bed will not be

built according to norm

BS8509.

C

smaller gap - no need to use spacer

Note that the slats in the

middle will have a gap

smaller than the spacer

lenght.

Important!

Cot/Bed base

must never be

dismantled once built.

Fix first two slats next

to the headboard and

footboard using bolts ,

washer and nut

Then, using spacer

work towards the middle of

the cot fixing slats to

the side rails using

screws .

H

I

J

G

Step 6

C

G

H

C

G

C

G

TODDLER BED

Assembling toddler bed

through the holes.

Remove all bolts from the

headboard, cotbase and

side frames and take the

cotbed apart. Then,

remove the bolts from the

first slats next to

headboards.

Fix the first slats next to the

headboards back using

bolts , washer and

nut through the holes.

.

Argos 604/5540 Assembly Instructions Manual

Argos 604/5540 Assembly Instructions Manual

Related papers

Other documents