Hagerco 45ET - Electrified Cylinder Escutcheon Wire Routing Instructions

Brand: Hagerco

Model: 45ET - Electrified Cylinder Escutcheon

Type: Wire Routing Instructions

5/8"

11/16"

3/8"

WIRE ROUTING HOLE FOR 45ET TRIM

3 5/8"

5/16"

EXIT DEVICE

MOUNTING HOLES.

EXIT DEVICE

MOUNTING HOLES.

WIRE ROUTING HOLE

FROM EXIT DEVICE TO

POWER TRANSFER DEVICE

(ELECTRIC HINGE).

EXIT DEVICE CHASSIS

LHR (LEFT HAND REVERSE) DOOR SHOWN ABOVE

RHR (RIGHT HAND REVERSE) DOOR SHOWN ABOVE

(SAME DIMENSIONS AS LHR)

3/8" [10] WIRE ROUTING

HOLE FOR 45ET TRIM

INSTRUCTIONS

NOTE: THIS IS A SUPPLEMENTAL INSTRUCTION FOR ADDING A

WIRE ROUTING HOLE TO THE SVR EXIT DEVICE CHASSIS WHEN

USING THE 45ET ELECTRIC TRIM WITH A 4500 SERIES EXIT DEVICE.

DETERMINE DOOR HANDING OF EXIT DEVICE AND IDENTIFY

LOCATION FOR WIRE ROUTING HOLE (SEE LHR OR RHR LAYOUT

DIAGRAMS).

DRILL A

3/8" [10mm] HOLE THROUGH THE CHASSIS USING

THE DIMENSIONS SHOWN.

ONLY ONE HOLE IS REQUIRED ON THE TOP SIDE OF THE

EXIT DEVICE TO ROUTE WIRES FROM THE 45ET ELECTRIC

TRIM THROUGH THE 4500 SERIES EXIT DEVICE.

THIS HOLE WILL LINE UP WITH THE WIRE ROUTING HOLE IN

THE DOOR, WHICH IS DESCRIBED IN THE 45ET TRIM

INSTRUCTIONS. SEE REFERENCE DOCUMENTS LISTED BELOW.

ONCE THE

3/8" [10mm] HOLE HAS BEEN DRILLED INTO THE

EXIT DEVICE CHASSIS, USE THE REFERENCED DOCUMENTS

LISTED BELOW FOR INSTRUCTIONS ON MOUNTING THE TRIM

AND EXIT DEVICE AND ROUTING THE WIRES.

REFERENCE DOCUMENTS:

I-ED00367 4500 SERIES ELECTRIC EXIT DEVICES

WIRE ROUTING AND DOOR PREP INSTRUCTIONS

I-ED00370 4500 SERIES ELECTRIC LEVER TRIM

ELECTRICAL SUPPLEMENTAL INSTRUCTIONS

T-ED00372 4500 ELECTRIC TRIM TEMPLATE

HOLE LOCATIONS

PRIMARY DIMENSIONS SHOWN IN INCHES,

DIMENSIONS IN [ ] ARE MILLIMETERS.

27390033

HAGER COMPANIES

139 Victor Street, St. Louis, MO 63104 - (800) 325-9995 - Fax (800) 782-0149

4500 HEAD CHASSIS WIRE ROUTING INSTRUCTIONS

FOR USE WITH 45ET ELECTRIC TRIM

SHEET 1 OF 1

DRAWING NO: I-ED00795

REV: -

Hagerco 45ET - Electrified Cylinder Escutcheon Wire Routing Instructions

Hagerco 45ET - Electrified Cylinder Escutcheon Wire Routing Instructions

Hagerco 45ET - Electrified Cylinder Escutcheon Wire Routing Instructions

Related papers

Other documents