DÉCOR Curved Wall Racks
DWR1 (24”) and DWR2 (30")
Enclosed you will find everything needed for the
installation and use of your storage rack. Two people
make installation easier.
Hardware included:
2 – 1 ½
"
Wood Screws
1 – Hex key
1 – Toggle Kit – ¼ x 20
Components included:
1 - Utensil Bar
6 – Straight Pot Hooks
INSTALLATION INSTRUCTIONS
'
1)
Determine where you wish to mount your rack. Make sure you locate your wall studs if you want
to mount into solid wood. You will want to use a level (not included) to make sure that the rack is
level. You may not be able to mount both ends to a wall stud as they are typically spaced at 16".
If it is not convenient to hang your rack directly into a wall stud you may use the included
DRYWALL
anchors enclosed with your rack. See Toggler® brand manufacturer recommendations
for weight limits included in the instructions in the Toggler kit.
2)
Locate the mounting keyholes on the back tabs of the bar. Hold the bar against the wall in its
desired location, mark the keyholes.
Carefully measure the area where the rack is to be hung and
install the 1 1/2" wood screws directly into the wall studs (or use the toggle instructions for drywall
mount). Do not screw flush to the wall, leave enough space for the rack. Using the keyhole (largest
part down), place the rack on the screws and drop into place. Tighten the screws.
It is important that your rack is installed correctly. If the unit is installed or used
incorrectly, it could become unstable and collapse, possibly causing injury.
Warranty. This product is warranted to be free of material defects for a period of five years from the date of purchase.
Your exclusive remedy for breach of this warranty shall be the repair or replacement of the defective product when
delivered, postage prepaid, to Enclume Design Products at 24 Colwell St. Port Hadlock, WA. 98339. There is no other
warranty, expressed or implied, and there is specifically NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PORPOSE. In no event will Enclume Design Products be responsible for any incidental or consequential
damages related to use of this rack.
WARNING
Thank you for choosing Enclume!
Enclume racks are the ultimate quality,
design, strength and function.
WARNING:READALLOFTHE
INSTRUCTIONSBEFOREASSEMBLINGAND
USINGYOURRACK
If you need help, please call 1-877-ENCLUME
EnclumeDesignProducts
24ColwellStreet,PortHadlock,WA98339
Phone360‐385‐6100Fax360‐385‐6156
www.enclume.com
-
1
Enclume DWR2 BK Installation guide
- Category
- Flat panel accessories
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Enclume OWR3 HS Installation guide
-
-
-
Enclume PR8BF-30 HS Installation guide
-
-
-
-
-
-
