Installation Instructions:

Flip up the bottoms of the back seats.

Remove jack from under the back seat (01½-03 trucks). Jack should be installed with an

angle bracket, wing nut, and seat belt or with two wing nuts. (In 00-01½ trucks, the jack

is installed under the front seat. If you have a 00-01½ truck, proceed to step 3.)

Slide passenger side end of the DU-HA against the seat bracket. Snap the other side

of the DU-HA around the driver side seat bracket. (You may have to bend the side inward

to snap into position.) (If you have a 00-01½ truck, proceed to step 6.)

Install the dividers by sliding them into the slots in the ends and bottom of the DU-HA.

Install the foam organizer/gun racks with the plastic stiffeners by sliding them into the

pre-cut slots in the dividers (as pictured below).

Safety Instructions:

Warning: Seat bottom must be latched down at

all times while vehicle is moving. Make sure the

DU-HA is secured in the vehicle according to

installation instructions. Do not store

Underseat Storage

Installation Instructions

DU-HA, Inc. // website: www.du-ha.com // phone: 1.866.306.DUHA (3842) // fax: 1.218.998.4013 // 306 Saint Andrews Street South, Fergus Falls, MN 56537

1

2

3

4

5

6

7