BMW 65 12 0 029 843 Installation guide
- Category
- Signal cables
- Type
- Installation guide
1
Installation kit for new generation radio
Valid for all cars with a black 17-pin radio connection plug
Retrofit/Installation kit No. 65 12 0 029 843
Important information!
The aerial diplexer fitted in the car must be replaced as set out in the electronic parts
catalogue (EPC).
Ensure that the cables/lines are not kinked or damaged as you install them in the car.
Additional cables/lines that you install must be secured with cable ties where necessary.
Parts and Accessories
Installation Instructions
1. To connect the adapter cable for the CD changer
(only required in cars with a CD changer)
Retrofit/Installation kit No.: 65 12 0 029 843 Date: 01.2001
EBA Nr.: 01 29 0 134 556
Push the shrink hose (1) over branch B1, silver 10-pin plug casing on the adapter cable and
connect it to branch A1, silver 10-pin socket casing on the control cable.
When connecting A1 to B1 ensure that they are correctly positioned, see figure.
All the sharp metal and plastic tips are to be cut off the plug connection A1 and B1 using an
angle cutter.
There must be no sharp edges or corners on plug connection A1 and B1.
Push the shrink hose (1) over the plug connection A1 and B1 and melt it with a hot air blower.
A1
A1
B1
1
A1
B1
B1
F 53 0795 B
2
B2
C2
F 53 0796 B
Connect the white 12-pin socket casing
B2 on the control cable to the new
general radio connection plug C2.
Connect the black 17-pin on-board monitor radio connection plug D1 on the on-board monitor
radio wiring harness to branch C1, black 17-pin plug casing on the adapter cable.
Affix a protective strip (2) on to the second protective strip (2) and then wrap it around the new
plug connection D1 and C1.
Retrofit/Installation kit No.: 65 12 0 029 843 Date: 01.2001
EBA Nr.: 01 29 0 134 556
F1
E2
E1
F 53 0798 B
Connect the coaxial plug E1 on the
adapter aerial cable to the coaxial socket
casing F1.
Connect the coaxial socket casing E2
and the new generation radio connection
plug to the new generation radio.
When installing the new generation
radio ensure that no cables area jammed
or damaged.
2. To connect the adapter cable power supply and speaker
2
C1
D1
C2
F 53 797 B
3. To connect the aerial adapter cable
-
1
-
2
BMW 65 12 0 029 843 Installation guide
- Category
- Signal cables
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
BMW 65 12 0 029 883 Installation Instructions Manual
-
-
-
-
-
-
-
-
-
