2. Andersen
  3. Dual-Arm Operator Bracket Replacement

Andersen Dual-Arm Operator Bracket Replacement Service Instructions

  • Hello, I've reviewed the document outlining the replacement of the Dual-Arm Operator Bracket for E-Series Casement Windows. This manual provides detailed steps and safety guidance to help you replace the sash bracket. I'm ready to assist you with any questions you have regarding the installation process or the components involved.
  • What tools are needed for this replacement?
    What should I do before starting the installation?
    Why is it important to support the sash during the process?
Sash Bracket
Tools Needed
∙Safety glasses
∙Phillips Screwdriver
∙Flat Blade Screwdriver
Parts Included
(1) Sash Bracket
Use caution when working at elevated heights and around unit openings. Follow
manufacturers’ instructions for ladders and/or scaffolding. Failure to do so may
result in injury or death.
Follow manufacturers’ instructions for hand or power tools.
Always wear safety glasses. Failure to do so may result in injury
and/or product damage.
9069236 BA Revised 09/26/13
Dual-Arm Operator Bracket Replacement
for E-Series Casement Windows with Standard Hinge
For questions call 1-888-888-7020. For more information and/or guides visit www.eaglewindow.com.
Please leave this guide with building owner.
▶Read guide from beginning to end before starting installation. Read all warnings and cautions during unit installation.
▶Check with your local building code ofcial to identify and conrm compliance with local building code requirements.
“Andersen” and all other marks where denoted are trademarks of Andersen Corporation and its subsidiary. ©2013 Andersen Corporation. All rights reserved.
Thank you for choosing Andersen.
Windows and doors can be heavy. Use safe lifting techniques and a reasonable number
of people with enough strength to lift, carry and install window and door products to avoid
injury and/or product damage.
Las puertas y las ventanas pueden ser pesadas. Utilice técnicas seguras de levantamiento
de peso y un número razonable de personas con suciente fuerza para levantar, cargar e
instalar los productos de puertas y ventanas, a n de evitar lesiones y/o daños al producto.
Sash must be supported during entire removal and
installation procedures. Failure to support sash may result
in injury and/or product damage.
La hoja debe sostenerse durante todo el proceso de
extracción e instalación. De no sostenerla, podrían
producirse lesiones y/o daños al producto.
2
9069236
1
Interior
Releasing operator arm allows sash to swing
freely. Sash may suddenly swing out and
break free causing injury and/or product
damage. Support sash during entire
replacement process.
Sash Track
Straight Operator Arm Roller
Straight
Operator Arm
Open sash to where straight operator arm is lined up with the arrow on sash track. Depress straight operator arm down to release from
sash track.
2
Interior
3
Interior
Slide clip away from bracket stud. Release split operator arm from bracket stud.
Split Operator Arm Clip
Bracket Stud
Bracket Stud
Split Operator Arm
4
Interior
Slide clip and release sash hinge arm from hinge channel.
Repeat for opposite hinge.
Sash Hinge Arm
Hinge Channel
Frame not
shown for clarity.
Hold sash rmly and slide upper and lower hinge shoes from ends
of hinge channel. Place sash on a at surface with interior side
facing up.
5
Interior
Hinge Shoe
Hinge Channel
Sash not shown
for clarity.
3
9069236
Remove sash bracket. Fasten new sash bracket in same position
using same screws. Dispose of old sash bracket properly.
6
Interior
Sash Bracket
Lift sash into unit opening. Position upper hinge shoe into upper
hinge channel rst, then lower hinge shoe into lower hinge channel
and slide sash in place.
7
Interior
Hinge Shoe
Hinge Channel
8
Interior
9
Interior
Position split operator arm on bracket stud.
Bracket Stud
Split Operator Arm
Hinge Arm
Hinge Channel
Position sash hinge arm on sash hinge channel stud. Slide clip
on sash hinge channel stud. Repeat for opposite hinge.
Hinge
Channel Stud
▶Operator bracket replacement is complete.
11
Interior
Align straight operator arm roller with arrow on sash track. Insert
straight operator arm roller in sash track.
Sash Track
Straight Operator
Arm Roller
10
Interior
Slide clip on bracket stud.
Clip
Bracket Stud
/