GrimmSpeed Ditch Light Brackets - 2018+ Crosstrek, 2019+ Forester, 2020+ Outback Installation guide

Model: Ditch Light Brackets - 2018+ Crosstrek, 2019+ Forester, 2020+ Outback

TRAILS by GrimmSpeed Install Guide Series

Ditch Light Bracket Install instructions – 18+ Crosstrek, 19+ Forester, 20+ Outback

Updated 5/26/2022

Introduction:

This guide will walk you through the install steps for The TRAILS by GrimmSpeed Ditch Light Brackets

Notes:

This install was done on a 2019 Subaru Crosstrek. Keep in mind that some steps may vary slightly by year, but

installation will generally be the same.

Tools:

• Ratchet Wrench

• 12mm Socket

If you have any questions don’t hesitate to contact us directly via email or phone:

1. Begin by propping your vehicles hood open. Locate the hood mount brackets and grab the corresponding bracket.

2. Working one side of the hood at a time, apply pressure to hood bracket while removing the (2) 12mm nuts. Place bracket on

as shown, and thread 12mm nuts on by hand.

3. Tighten both 12mm nuts and check clearances before closing hood.

4. Repeat on opposite side.

Model: Ditch Light Brackets - 2018+ Crosstrek, 2019+ Forester, 2020+ Outback