Thank you for purchasing a quality VALCO product. Please read and follow the instructions outlined in this

guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all

the warnings and safety guidelines before use.

Retain this guide in a safe place for future reference.

PRODUCT REFERENCE GUIDE

GRACO/PEG PEREGO/BRITAX CAR SEAT ADAPTOR

© Copyright VE 2007

Due to our policy of continuous product

development, this product is constantly

valcobaby.com to obtain the most up to date

information before use. Include the batch

number, which can be found on a sticker on

the frame.

All pictures and diagrams herein are provided

for illustration purposes only. Actual product,

color or fabric may vary. VALCO reserves the

right to modify or alter any specication or

color without notice or obligation to modify

any product previously purchased

416 488 1900

FOR USE WITH GRACO

SINGLE/TWIN

CAR SEAT ADAPTOR:

If you haven’t already done so, remove

the front bar or plugs from the nylon

housings on either side of the stroller

frame by pressing each inner ‘release

button’ and lifting the front bar or plug

from the housing.

straps. The rst set (as shown in Figure

C) rest on the foot rest of the stroller.

Adjust these straps so they wrap

underneath the foot rest of the stroller.

Secure by inserting the male clip into

the female end.

Ensure these straps are as tight as

possible.

To secure the Twin Adaptor see Page 3

‘Secure the Twin Adaptor’.

frame ensuring that the Car Seat latch

(red lever on back of car seat) rests

under the Adaptor frame.

Once the car seat is in position, take

the second set of tether straps and

place them through the sides of the car

seat, (where a seat belt would go) and

connect via the buckle.

Ensure that the strap is tight and

TO REMOVE THE ADAPTOR:

Detach the straps secured beneath the

footrest.

Locate the two nylon release buttons

that sits below the frame at each side of

the stroller.

Press the release button and lift the

adaptor bar out of the nylon housings.

TO SECURE TWIN CAR SEAT

ADAPTOR:

To secure these straps;

Lift up the footrest ap (Figure C-1- 2 )

and insert the Male clip through the slit

in the stroller frame directly above the

footrest (Figure C-1- 3 ).

Wrap the Female clip around the

closest side of the stroller, meeting the

Male clip underneath the footrest of the

stroller.

Insert the Male clip into the Female clip,

If you haven’t already done so, remove

the front bar or black plugs from the

nylon housing at either side of the

stroller frame by pressing each inner

“release button” and pulling the front

bar/plug upward.

Line up the Car Seat to the Adaptor

frame ensuring that the Car Seat latch

has clicked on the Adaptor frame.

Once the car seat is in position, thread

the tether straps through the sides of

the car seat, (where a seat belt would

go) and connect the buckle.

Ensure that the strap is tight and

secure by pulling on the free end of the

TO REMOVE THE CAR SEAT ADAPTOR:

Locate the two nylon release buttons

that sit below the frame at each side of

the stroller.

Press the release button and lift the

adaptor bar out of the nylon housings.