Page is loading ...
MT5074
Screw Package
Parts
Left and right hooks x1
Wall plate (left) x1 Wall plate (right) x1
(4) Self-drilling screw -A (4) Plastic anchor -B (4) M4x20 -C
(4) M5x25 -D (4) M6x25 -E (4) M8x25 -F
(4) φ8x14x6
Higher spacer -G
(4) φ8x14x11
Higher spacer -H
(4) φ5 Washer -I
(4) φ6 Washer -J (1) Bubble level -K (4)M6x8-L
Assemble wall plate Fits TV：32”-70”
1. Align left plate with right plate and tighten it with screw L,
as shown below.
L
Preparation:
Check VESA pattern of TV before installation
Load capacity: Max 60kg
2. Complete the wall plate unit.
Read the instructions before you begin.
•If you are unsure of any parts of the process, contact a
professional contractor or installer for assistance. Improper
installation can result in injury or damage.
•Check package contents against the Supplied Part List in the
instruction to assure that all components are received
undamaged.
•Do not use damaged or defective parts.
•Do not use this product for any purpose or in any configuration
not explicitly specified in this instruction.
Check the screws every two months.
ATTENTION
We hope you never have the need,but if you do,
our service is friendly and hassle-free.
:after-sales@suptekmount.com
Attach hooks and TV and plate parts
1.Attach hooks and TV.
3.Tighten the screws.
Use bubble level to adjust the bracket to horizontal
position and mark the hole site on the wall.
Use bubble level to adjust the bracket to horizontal
position and mark the hole site on the wall.
4.Angle adjustment of TV
2.Hang the TV to the wall plate
You may need
assistance to
hang it.
Installation in concrete wall
Installation in wooden wall
Loosen the knob,
tilt 15° forward or
backward.
/
