TALA Basalt Single Pendant in Brass Operating instructions

Brand
TALA
Model
Basalt Single Pendant in Brass
Type
Operating instructions
RECOMMENDED EQUIPMENT
- Small at head screwdriver
- Wire strippers
- Insulation tape
- M10 (17mm) (5/8IN) spanner or Adjustable
spanner
Further equipment may be required for xing
to your ceiling.
INSTALLATION
GUIDE
Basalt Single Pendant
SKU - BSALT-I-SET-SGL-PD-01-US
SKU - BSALT-I-SET-SGL-PD-02-US
IP20 120V
BEFORE STARTING
We advise the tting of our ceiling rose and pendant to be
performed by a qualied electrician. Please read through these
instructions before commencing work, and keep them for future
reference. Please take extreme care when carrying out these
instructions.
Important! This light tting must be connected to the supply earth.
If your lighting circuit does not have an earth, ask a qualied
electrician to provide an earth facility. This light tting is suitable for
indoor use only. This tting operates on 120V mains voltage. Please
visit our website to see our reccomended dimmers
Warning! Always switch off electricity supply at the mains during
installation and maintenance. We recommend that the fuse is
withdrawn or the circuit breaker is switched off whilst work is in
progress. Do not just turn off at the wall switch. All ttings must be
installed in accordance with current NFPA 70, National Electrical
Code (NEC)
BASALT TRIPLE - PROVIDED COMPONENTS
x1 Tala Basalt
pendants
x1 Ceiling Plate
A
A
A
x1 Tala Basalt bulbs
C
B
B
x2 at head bolts
x1 Ceiling Bracket
DD
E
E
C
A
STEP 1
Attach to the ceiling using
screws and plug. Always choose
screws and plugs that are
appropriate for the ceiling.
Mains supply
120V
xings not
included
STEP 2
Adjust the cord to your desired
length. Using a at head screw
driver, tighten ‘grub/set screw’
This will secure the cable in place.
Maintain all double insulation
STEP 3
Cut off excess cable and strip wires
to expose the copper core. Maintain
all double insulation.
STEP 4
First identify your household
wiring using current Building
Regulations and IEE Wiring
Regulations. Attach the
pendant wiring to your
household supply as shown.
Use an appropriate junction
box.
C
C
B
B
White (N)
White(N)
Tala
Pendant
House hold Mains
120V IN
Black or Red (L)
Black or Red (L)
L N E
Green/Yellow
(earth) Attached
to Part
Green/Yellow
(Earth)
A
STEP 6
Lift metal sleave and screw
in the bulb rmly.
Take care not
to let the metal sleeve fall onto
the bulb
STEP 6
Fasten part
to part using
the bolts provided.
A
A
E
E
B
B
CC
C
STEP 7
Rotate metal steeve To align
with the bulb
Carefully lower metal sleeve
onto the bulb. you can now
make and nal tweeks to the
alignment of the bulb and
sleeve.
C
C
C
CARE AND CLEANING
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these
will damage the nish of the product.
WARRANTY AND AFTER-CARE
This product has a three-year warranty. Within this time we will replace any parts that
have functional defects. Please report any faults by emailing:
[email protected]
ADJUSTING THE CORD
To adjust the cord to your desired length, using a
at head screw driver, loosen the grub/set screw
and push the cable up into the ceiling plate.
Secure the cable in place by re-tightening the grub
screw. Maintain all double insulation.
1
1
DISTANCE BETWEEN PENDANTS
When arranging pendant drops, plan the
location of each pendant on the ceiling.
Recommended minimum distance
between the centre of each ceiling rose
is 180mm (7in).
A
A
Pendant 1
Pendant 2
TOP VIEW
Pendant Layouts
A
B
MINIMUM CORD LENGTH
For all bulbs shortest recomended cord
length is 350mm (14in)
A
DISTANCE BETWEEN PENDANTS
Recommended minimum distance between pendant is 100mm (4in)
B
PENDANTS - RECOMMENDED CABLE LENGTHS
SCENARIO 1 - OVER COFFEE
OR DINING TABLES
Where height is required for
seated tasks
SCENARIO 2- OVER SIDE OR
BEDSIDE TABLE
Where height is only required
for storage.
Minimum Distance
700mm (28in)
Minimum Distance
500mm (19in)
SCENARIO 3 - OVER KITCHEN
ISLAND OR BAR
Where height is required for
standing tasks.
Minimum Distance
800mm (32in)
Join the Community
Instagram: @tala | Facebook: talaHQ | Pinterest: TalaLED | Tag: lighttoliveby
Tala Studios, 25B Vyner Street, London E2 9DG | +44 20 3026 3246 | [email protected]
Minimum Distance
2.2m (7Ft)
SCENARIO 4 - OVER A
STAIRWELL OR WALKWAY
Where height is required for
walking underneath.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

TALA Basalt Single Pendant in Brass Operating instructions

Brand
TALA
Model
Basalt Single Pendant in Brass
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents