2. FOERSTER TECHNIK
  3. FOERSTER-TECHNIK Combi Automatic Calf Feeder
FOERSTER-TECHNIK Combi Automatic Calf Feeder

FOERSTER TECHNIK FOERSTER-TECHNIK Combi Automatic Calf Feeder User guide

  • I've reviewed the user guide for the combi automatic calf feeder. This guide details the steps for recommissioning the device, covering everything from physical connections, setting up external detergent supply as well as first settings at the handheld like entering date, time, filling heat exchanger, calibrations and cleaning process. I am ready to answer your questions about this device.
  • What should be checked before recommissioning?
    What should be done after cleaning?
    What kind of hose should be used to connect water or milk tank?
50-80 cm
10-15
cm
MP
10
OFF
ON
8
7
9
1
2
3
4
5
4
8
6
7
5
6
10
11
11
12
3
2
Connect water
Connect power
Establish potential equalisation
Connect milk tank
Provide draining options
Place milk tank next to the feeder on
same or on higher level.
Use a new hose!
Left sideRight side
• On the left side of the feeder
• In front of the feeder in the middle of the
housing
• At every feeding station
This document gives a brief overview of the most important steps when recommissioning a feeder.
QUICK START GUIDE
Automatic calf feeder - combi
1.12 Recommissioning
Remove dummy plug / sealing cap
Open door on the left side and plug in
Ethernet cable
Connect Ethernet cable and, if
necessary, antenna cable
TIPP: check QuickStartGuide 2.3 CalfCloud
MP
This checklist refers to the basic equipment of the calf feeder. Not all available functions of the automatic feeder or the extensions can be shown.
For detailed information and valid warnings as well as safety instructions, please refer to the instructions manual. (Status 23/02)
Remove the protective cover
Place the feeder in the desired position and clean the outside with a damp cloth.
Mounting the protective grid/cover of the powder hopper attachment
Fill up MP
Use a new hose!
Attach new teats and suction
hoses
Install external detergent supply
Turn the automatic feeder on
Check storage level and re-ll if necessary.
Enter
Auto
i
C
Esc Enter
123
6
5
4
789
0
15
14
16
13
QUICK START GUIDE
Automatic Calf Feeder - 1.12 Recommissioning
First settings at the Handheld
Fill the heat exchanger
Fault message HE not lled is automatically displayed
press HE is lled now
Enter basic settings (date & time)
ESC
= back
ENTER
= conrm
Calibration
Calibrate all existing components at least 3 times during initial commissioning.
calibration Components
Water, MP, milk, additives, detergent
TIPP: check QuickStartGuide 1.3 & 1.4 Calibration
Attention: detergent quantity is set to 0ml by default
TIPP: check QuickStartGuide 1.6 & 1.7 Cleaning
Cleaning before recommissioning
Check cleaning settings
Cleaning
Start circuit cleaning
Cleaning settings
circuit cleaning
start?
This checklist refers to the basic equipment of the calf feeder. Not all available functions of the automatic feeder or the extensions can be shown.
For detailed information and valid warnings as well as safety instructions, please refer to the instructions manual. (Status 23/02)
After cleaning, check all components
again for leaks.
/