2. FOERSTER TECHNIK
  3. Automatic Calf Feeder

FOERSTER TECHNIK Automatic Calf Feeder User guide

  • Hello! I've reviewed the user guide for the FÖRSTER TECHNIK calf feeder Powder. This document outlines the recommissioning steps, from connecting water and power to setting up drainage and installing detergent. I'm ready to answer questions you might have about the process and features of this device.
  • What type of hose should I use to connect water to the feeder?
    Where can I find draining options?
    What should I do before connecting the Ethernet cable?
50-80 cm
10-15
cm
MP
OFF
ON
7
6
8
1
2
3
4
5
4
7
6
5
9
10
10
11
3
2
9
Connect water
Connect power
Establish potential equalisation
Provide draining options
Left sideRight side
• On the left side of the feeder
• In front of the feeder in the middle of the
housing
• At every feeding station
This document gives a brief overview of the most important steps when recommissioning a feeder.
QUICK START GUIDE
Automatic calf feeder - Powder
1.12 Recommissioning
Remove dummy plug / sealing cap
Open door on the left side and plug in
Ethernet cable
Connect Ethernet cable and, if
necessary, identication cable
TIPP: check QuickStartGuide 2.3 CalfCloud
MP
This checklist refers to the basic equipment of the calf feeder. Not all available functions of the automatic feeder or the extensions can be shown.
For detailed information and valid warnings as well as safety instructions, please refer to the instructions manual. (Status 23/02)
Remove the protective cover
Place the feeder in the desired position and clean the outside with a damp cloth.
Mounting the protective grid/cover of the powder hopper
Fill up milk replacer
Use a new hose!
Attach new teats and suction
hoses
Install external detergent supply
Turn the automatic feeder on
Check storage level and re-ll if necessary.
Enter
Enter
Enter
Enter
Auto
i
C
Esc Enter
/