Winmate C350T Series User manual

Category
Handheld mobile computers
Type
User manual
C350T Series PDA
User Manual (V1.0)
Notes:
All screens in this guide are simulated. Actual displays may be different.
Depend on the different software version on your C350T; you may get different
screens with same tasks.
Unless specified otherwise, all instructions to perform tasks in this guide
assume that you are starting from the home screen.
I
Before starting to use C350T
1) Insert Micro SD / SIM card (Optional)
The built-in storage space of your C350T series PDA is mainly used for operation
system. To enable some functions need bigger storage space, such as camera or
other APP, please insert a Micro SD card before using. If your C350T series PDA
supports 3G, remember insert a SIM card to activate your data connection.
2) Charge the Battery
The battery in your new C350T series device is not charged yet. Please charge with
the bundled USB cable before your first use.
Caution! Please don’t remove the battery pack or try to take this PDA apart
while the C350T is charging. These actions will result in some damages and may
invalidate your warranty.
3) Some tips for using and caring your PDA
Your C350T series PDA is designed to resist damages from certain rugged
conditions. However, to help care for your PDA, please avoid prolonged or extreme
exposure to those conditions.
To ensure the rugged design works and protects your PDA, please be sure
the USB connector cover isclosed and the back cover is screwed properly.
Don’t leave your PDA near a heat source; this can damage the device.
Avoid dropping your PDA on a hard surface; this can potentially cause
damage to the device.
To clean your PDA, use a dry soft cloth. Don’t use alcohol or other cleaning
solutions.
Please don’t have your PDA contact with water when the cover is opened.
The water-proof design works only when the outer case is sealed properly.
Note: Certain apps and features may not be available in all countries.
II
C350T Outlook
Front View (without Barcode / RFID Reader)
Function Button
Function Button
Proximity Sensor
Receiver
3.5” Touch Screen
Micro USB Port
(B type)
Microphone
Version for Android OS:
Menu Home Back
Version for Windows OS:
Function 1 Start Function2
Power indicator
Flashing
Green
Power
On/Off
Amber Charging
Red Low power
Power
Button
Press Sleep
Hold Power on / off
III
Back View (without Barcode / RFID Reader)
LED Flash Light
5M Pixel Camera
Speaker
Docking Connector
Stylus
IV
Front View (with Barcode / RFID Reader)
Function Button
Function Button
Proximity Sensor
Receiver
3.5” Touch Screen
Micro USB Port
(B type)
Microphone
Version for Android OS:
Menu Home Back
Version for Windows OS:
Function 1 Start Function2
Power indicator
Flashing
Green
Power
On/Off
Amber Charging
Red Low power
Power
Button
Press Sleep
Hold Power on / off
V
Back View (with Barcode / RFID Reader)
Bar Code Reader
RFID Reader
Sensor
C350T-BR1 or C350T-BR2
= 1D/2D Barcode Reader
C350T-B1R or C350T-B2R
= 1D/2D Barcode + HF RFID Reader
Stylus
Docking Connector
VI
Key Pad Table:
CONTENTS INDEX
Set up & Go ...............................................................................1
Power On/Off ............................................................................ 5
Touch Screen and keys...............................................................6
Home Screen & Status.............................................................12
Set up Language ...................................................................... 16
Set up Date & Time ................................................................. 16
Internet Connection ................................................................ 17
Bluetooth................................................................................. 19
App Menu................................................................................ 21
Software Update......................................................................23
Text entry.................................................................................24
Messaging................................................................................25
Camera.................................................................................... 26
Photo & Video......................................................................... 29
1
SET UP &GO
1. Turn Off the PDA
Make sure the PDA is powered off and the USB cable is un-connected before you
remove the back cover.
Note: Please refer to page 5 for the details scenarios about how to turn off
your C350T PDA under Android OS.
2. Open the Back Cover
Make the PDA facing down, and then unscrew the 2 buckle. Gently pull out the
back cover.
2
3. Remove the Battery
Pull the plastic strap on the battery, and then remove it.
4. Insert SIM Card
Insert the SIM card (with its gold contacts facing down and cut-off corner facing
inside) all the way into the SIM card slot.
3
5. Insert Micro SD Card
Open the SD card holder by pushing the metal cover backward and lift it. Put the
Micro SD card into the socket, close the metal cover, and push forward till it
lucked.
6. Put back the Battery
Reinsert the battery by latching the bottom first and then put it down.
1
2
4
7. Put back the Back Cover
Put back the back cover and make sure all the 2 buckles fit those on the device to
fix the back cover.
8. Using the Stylus
CAUTION! Never use anything other than the C350T stylus on the screen.
Otherwise this could cause a permanent damage.
(1) Remove the stylus from its holder.
(2) Hold the stylus as you hold a pencil.
(3) To make a choice from a menu, lightly tap the tip of the stylus on that choice.
(4) To write data into a field on a form, use the stylus to print the letters or numbers.
Using very light pressure.
5
POWER ON/OFF
To turn on your C350T:
Press and hold Power button about 1 second. You can feel a slight vibration
when your C350T series PDA is turned on.
Drag from left to right to un-lock the screen.
To turn off your C350T:
Press and hold Power button till the following window show up.
Tap Power off, and then touch OK.
You can also force the system to shutdown anytime by holding the Power
button
about 8 seconds.
6
TOUCH SCREEN
Display & Touch Screen On/Off
To save battery power, press the Power button to have the display & touch
screen off and to force your C350T enter sleep mode.
You can also have your C350T goes to sleep automatically by pressing:
> Settings > Display > Screen timeout.
To wake up your C350T, just press Power button again and drag from left to
right to unlock the screen.
Note:
When you hold C350T close to ear during voice transmit, the touch sensor
enters sleep mode automatically to prevent accidental touches.
Your touch screen might stay dark if the Proximity & Light sensor is covered.
Don't use covers or screen protectors (even clear ones) that cover this sensor.
Proximity & Light Sensor
7
Adjust Screen Brightness
Find it: > Settings > Display > Brightness
Here you can see a brightness adjustment bar.
Drag the slider to left to decrease or to right to increase the screen brightness.
Press OK to finish your settings.
Rotate the screen
Your C350T can rotate its display automatically to stay right-side up while changing
the screen orientation.
Find it: > Settings > Display > Auto-rotate screen
8
Touch Tips
One Touch: Choose an icon or option
Press and Hold: Show options
Drag: Scroll or move slowly
Flick: Scroll or move quickly
Zoom: Pinch the screen with two fingers apart or together to zoom in or out
on Google Maps™, web pages or photos.
Slide two fingers apart
or together to zoom in
or out.
Drag or flick to scroll.
Touch & hold to show options.
9
KEYPADS AND FUNCTION BUTTONS
Main Function Keypads
Menu Home Back
Touch to close any menu or app and return to home screen.
Or touch and hold on home screen to find the latest apps used.
Touch to open menu options.
Touch to return to the previous page.
10
Keypads
The keypad enables you to both enter information and interact with the PDA
operating system and also operate secondary functions using the function button.
When the green function button is pressed, the orange icon functions on the keypad
become available.
When the Function button
is pressed, an icon
appears in the operating system and LED indicator show
blue color:
The following table describes the keypad keys:
Function Active Icon
LED Indicator shows BLUE
11
Power Key Menu
Press and hold Power Button for 3 seconds to open
the power key menu, where you can:
Mute the PDA from “Silent mode”
Turn off all wireless functions, including the
call function, data services, Bluetooth, and
Wi-Fi from
“Airplane mode”
Turn off your C350T from “Power off”
Adjust System Volume
Press the FUNC keys to jump to function-key-layer:
Ringer volume
- on the home screen
Earpiece volume
- during a call
Media volume
- when playing music or video files,
Adjust Screen Brightness
Adjust brightness in function-key-layer
Enable / Disable Key Pad backlight
Adjust brightness in function-key-layer
- Brightness +
Key Pad BL Enable / Disable
- Volume +
12
HOME SCREEN &STATUS
Home Screen
Home screen gives you all your latest information in one place. It is the screen you
can see when you turn on C350T or touch
from a menu.
Home screen also provides a space where you can personalize your C350T by setting
different wallpaper or having shortcuts of the apps frequently used.
Status Bar
Shortcuts
Touch to open
Widget
Touch to use
Touch to open the app menu
Notification:
Drag this bar down to see details.
Flick left or right to see more panels or
widgets
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38

Winmate C350T Series User manual

Category
Handheld mobile computers
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI