Crestron SPC-122 User manual

Crestron SPC-122 SmartPresenter™ Cable

Crestron Electronics, Inc. Operations Guide - DOC. 5780

15 Volvo Drive SmartPresenter™ Cable: SPC-122

Rockleigh, NJ 07647 07.99

Tel: 888.CRESTRON Specifications subject to change without notice.

Fax: 201.767.7576 www.crestron.com

SmartPresenter™ Cable: SPC-122

The SPC-122 is designed for the SmartPresenter™ and used to control specific

serially-controlled devices. The entire length of the cable is approximately 15 feet

(4.572 meters) with a RJ11 (6-position, 6-pin) connector at one end and a DB9M

connector at the other end.

Physical View of the SPC-122

UNMARKED PINS

ARE NOT CONNECTED

AS VIEWED FROM

SOLDER CUP SIDE

15 FEET

(4.572 METERS)

BLK #5 (GND)

RED #3 (TX)

GRN #2 (RX)

WHT

PIN #1

NOTE: Alteration of the SPC-122

in any manner may affect its

performance within the control

system. Crestron cannot

guarantee its behavior if altered.

A serially-controlled device can be controlled with the SmartPresenter™ only if the

appropriate Q-Code is assigned to OUTPUT 4 on the SP-1. The SP-1 recognizes the

Q-Code as an RS-232 switching device and outputs commands for that device to the

PC port (rather than the OUTPUT 4 port). Use the SPC-122 to connect the SP-1 to

the serially-controlled device (refer to illustration below). Only those devices with a

cable code “c” designation in the Crestron Q-Codes table (latest version of the

SmartPresenter Quick Guide, Doc. 5742) require the SPC-122.

Hookup Connection for Controlling a Serially-Controlled Device

SPC-122

SERIALLY-CONTROLLED

DEVICE