FB23008, FB23009
Jeep® JK Wrangler
Rocker Guards – 2DR & 4DR
2300800
REQUIRED TOOLS
16mm Socket &
Extension
KIT CONTAINS
Rocker Guard – Left
Rocker Guard – Right
QTY
1
1
1) REMOVE FACTORY RAILS/GUARDS
Remove the factory equipment if equipped.
2) INSTALL ROCKER GUARDS
Using a 16mm socket, remove the nuts on either
side of the body mount bolts. Complete this step on
both the front and rear brackets.
Identify the driver and passenger side. The front of
the rocker guard is welded in the center of the
bracket as seen below. The rears are welded off-
center of the bracket.
FB23008 – 2DR
FB23009 – 4DR
FB23009 shown
FB23008, FB23009
Jeep® JK Wrangler
Rocker Guards – 2DR & 4DR
2 2300800
NOTE
The use of a floor jack to lift the rocker guard into
position can help if you do not have someone to
help hold it in place.
Install the rocker guard by lifting it into position
over the body studs. Reusing the OEM nuts, secure
the rocker guard in place.
3) HIT THE TRAILS AND ENJOY YOUR NEW ROCKER
GUARDS!
/
