2. Fishbone Offroad
  3. FB24022

Fishbone Offroad FB24022, FB24023 Installation guide

  • Hello! I have analyzed the provided installation instructions for the Fishbone Offroad tube doors, models FB24022 and FB24023. The document outlines the simple steps needed to replace your Jeep's doors with these tube doors using a few basic tools. I'm ready to answer any questions you have about the installation process or the product itself.
  • What tools are needed for installation?
    Are these tube doors for 2-door or 4-door jeeps?
    What do I need to do before installing tube doors?
FB24022 & FB24023
Jeep® JK Wrangler
Tube Doors – 4DR and 2DR
2402200
REQUIRED TOOLS
13mm Socket/wrench
4mm Allen wrench
KIT CONTAINS
Stainless nyloc nut (2DR)
Stainless nyloc nut (4DR)
QTY
4
8
1) REMOVE DOORS
Begin by removing your OEM or existing doors. Take
care not to scratch the doors when removing and
place them on a soft surface to protect the paint.
2) INSTALL TUBE DOORS
Insert the tube doors into the Jeep’s body hinges and
secure with supplied nyloc nuts using a 13mm
wrench or socket. Do not overtighten as this may
make the door hard to open.
FB24022 – 4DR (SHOWN)
FB24023 – 2DR (FRONTS ONLY)
FB24022 & FB24023
Jeep® JK Wrangler
Tube Doors – 4DR and 2DR
2 2402200
3) ATTACH DOOR CATCH STRAP
Install the attached door catch strap to the hook
inside the Jeep.
4) ADJUST LATCH MECHANISM
Using a 4mm allen wrench, adjust the latch
mechanism until the door closes smoothly.
5) ENJOY YOUR FISHBONE OFFROAD TUBE DOORS!
Front door shown
FB24022 only – rear door shown
/