Legrand 8 Port Video Interface Module-363915-01, IS-0086 Installation guide

Category
Signal cables
Type
Installation guide
1. Introduction
The OnQ 8 Port RF Interface Module, Part Number 363915-01, provides for the management and distribution of
RF signals (Cable TV, off air, satellite and internal signals) on coaxial cable throughout the house. When com-
bined with OnQ Video Modules, the RF Interface allows for the combining and distribution of these signals. The
RF Interface also provides a convenient location for the termination of any unused coaxial cable to be used in
future applications. The modules can be mounted in OnQ Raised Rail or Flat Rail Service Center Enclosures.
2 . Description
The RF Termination Module has low-loss “F” style fittings for connecting all incoming and outgoing signals. The
module allows for 8 signal inputs/outputs. The 8 Port RF label allows for the identification of “room locations” on
the front of the module (Figure 1).
3. Installation
A. Mounting in enclosure (Figure 2).
1) Align tabs on module with slots on rail of enclosure.
2) Insert tabs by angling module away from the back of
the enclosure and sliding forward.
3) Rotate the module and insert fasteners on module
into corresponding holes on rail of enclosure.
(Plunger must be in the pulled out position for
fastener to engage hole.)
4) Push plunger in to lock module. Pull on module to
assure module is locked properly in place.
NOTE: Recommended location for RF Termination
Module is upper right side; however, module may
be mounted in any available space.
NOTE: Do not
bend cable in less than about 2 inch
radius.
B. Cable Connections
1) Identify cable(s) and route to fitting(s) on module. In
routing cable, allow slack for bundling cables to the
side. Trim cable to allow loose loop of cable to the connection.
2) Attach a Series 6 “F” connector to the cable. Connect to fitting on module and finger-tighten.
3) Attach RG6 cables from module to desired locations in enclosure.
OnQ Technologies, Inc.
P.O. Box 60907
Harrisburg, PA 17106-0907
800-321-2343
www.onqtech.com
Installation/Instruction Sheet
8 Port RF Interface
IS-0086 Rev. O
IS-0086 Rev. O Page 1 of 1
Ref. P/N 363605-86
363915-01
"WHITE FIELDS" ARE
PROVIDED FOR THE
PURPOSE OF
RECORDING
"ROOM LOCATIONS"
1
2
3
4
5
6
7
8
RF/VIDEO TERMINATION MODULE
Figure 2
Figure 1
  • Page 1 1

Legrand 8 Port Video Interface Module-363915-01, IS-0086 Installation guide

Category
Signal cables
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI