Minka Group 6460-84 User manual

Minka Group
Brand
Minka Group
Model
6460-84
Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
For Model#6460 (Rev. 02/27/2012)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BRE AKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old
fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Attach the circular strap (A) to the outlet box using two
outlet box screws (B) (Size: #8-32N*L0.5”). The side of
the circular strap marked “GND” must face out.
4. Thread the two mounting screws (C) about 1/4” into the
pre-drilled holes in the circular strap (A) spaced the same
distance apart as the holes in the back plate (F).
CONNECTING THE WIRES (Fig. 2)
5. At the point, connect the electrical wires as follow; connect
the black wire from the fixture to the black house (hot)
wire. Connect the white wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured.
You may wrap the connections with electrical tape. If your
outlet has a ground wire (green or bare copper) connects
fixture’s ground wire to it. Otherwise connect fixture’s
ground wire directly to the circular strap using the green
screw provided. After the wires are connected tuck them
carefully inside the outlet box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Place the back plate (F) over the circular strap (A) and
adjust the holes to fit the mounting screws (C), and then
secure the back plate (F) against the wall using cap nuts
(D).
7. Install light bulbs in accordance with fixtures specification.
(DO NOT EXCEED MAXIMUM WATTAGE RATING!) (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
8. Install glass shade (E) by referring to fig 1.
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2049E
A
B
C
D
F
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
MIN 90℃ SUPPLY CONDUCTORS
Set# A-020
- Circular strap
- Ground screw
- Mounting Screw*2
  • Page 1 1

Minka Group 6460-84 User manual

Minka Group
Brand
Minka Group
Model
6460-84
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents